vsat

Introduction
• VSAT = Very Small Aperture Terminal
• Early Earth Stations in commercial systems
were very large and expensive (30 m).
• Need to make system more affordable to end
user:
• Increased transmit power from satellite.
• Higher frequencies
• Result: Smaller ES antenna size required.
 Large Antenna Systems
• Breakpoint between “large” and “small”
antennas is at about 100 wavelengths.
• Above breakpoint, “back-fed” configurations
such as Cassegrain or Gregorian are
economically and technically viable
(subreflectors need to be at least 10
wavelengths).
• Below breakpoint, terminals called Small
Aperture Terminals.
• Smaller Antennas  Tighter Link Budgets
Cassegrain,gregorian and vsat
 Typical Antenna Sizes
• At C-band: below 5 meters (100 wavelength
at 6 GHz).
• Extrapolation of terminology:
USAT = Ultra Small Aperture Terminal.
• Standard VSAT antennas
• Smaller antennas are also included in the
concept of VSAT or USAT (DTH, MSS, etc).
USAT
Applications
 VSAT SYSTEMS
• Underlying objective of VSAT Systems:
bring the service directly to the end-user
• Major reasons for doing this
– Reduce hierarchical distribution network (make
more efficient and faster - e.g. POS credit)
– Reduce distribution costs Point of Service
– “Leapfrog” technology in developing countries
(e.g. VSAT/WLL)
What is a wireless local loop?
• In a telephone network, a wireless local
loop (WLL) is a generic term for an
access system that uses a wireless link
to connect subscribers to their local
exchange in place of conventional
copper cable. Using a wireless link
shortens the construction period and
also reduces installation and operating
costs.
 VSAT/WLL

• Telecommunications and roads are the two

major economic growth requirements for
developing countries
• Major telecommunications infrastructure
does not exist in many developing countries
• SOLUTION
– Distribute links to communities by satellite/VSAT
– Use Wireless Local Loop from the VSAT
 VSAT/WLL

• The geostationary satellite is used to link a large

number of VSATs with the main switching center in a
large city.
• Each VSAT acts as the link to the local switching
center in the village or rural community, with the final
mile of the telephony link being carried over a
Wireless Local Loop.
VSAT/WLL
 VSAT/WLL User density
dependency
• Economic advantages of VSAT/WLL
solution depends primarily on user
density.
• Physical distances, major
transportation routes, and geographic
barriers, as well as the individual
country’s demographics and political
influences, can alter the breakpoints.
Motivation to use VSAT/WLL

VS

• The last mile problem

• Hard to reach areas
• Reliability
• Time to deploy (4-6 months vs. 4-6
weeks)
• Flexibility
• Cost
 VSAT/WLL User density
dependency
~0 Users/km2 ~10 Users/km2 ~100 Users/km2 ~1000 Users/km2

User Density in number of users per square

kilometer

Uneconomic: VSAT/WLL: Fiber/Microwave FS:

Requires appears the Traditional terrestrial Fixed
Service appears the best
Large subsidy for best
technological implementation
any technological
implementation implementation

Approximate economic break-points in the

implementation choices for serving new regions with
different population densities.
Implementations
 VSAT IMPLEMENTATION
• There are three ways VSAT services
might be implemented
– One-Way (e.g. TV Broadcasting satellites)
– Split-Two-Way (Split IP) Implementation
(return link from user is not via the
satellite; e.g. DirecTV)
– Two-Way Implementation (up- and down-
link)
We will be looking at Two-Way Implementation only
 VSAT IMPLEMENTATION
• There are basically two ways to
implement a VSAT Architecture

• STAR
– VSATs are linked via a HUB
• MESH
– Each VSAT is capable of communicating
directly with any other VSAT. Network
control and duties of hub can be carried
over by any of the VSAT or master control
station duties are shared among the
VSATs.
 VSAT IMPLEMENTATION

Higher Propagation delay Lower Propagation delay (250 ms)

Used by TDMA VSATs Used by PAMA/DAMA VSATs
High central hub investment Lower central hub investment
Smaller VSAT antenna sizes (1.8 m larger VSAT antenna sizes (3.8 m typically)
typically) Higher VSAT costs
Lower VSAT costs Suited for high data traffic
Ideally suited for interactive Telephony applications and point-to-point
data applications
high-speed links
Large organizations, like banks, with
centralized data processing
requirements
VSAT STAR ARCHITECTURE
• In this network architecture, all of the traffic is
routed via the master control station, or Hub.
• If a VSAT wishes to communicate with another
VSAT, they have to go via the hub, thus
necessitating a “double hop” link via the satellite.
• Since all of the traffic radiates at one time or
another from the Hub, this architecture is referred
to as a STAR network.
VSAT STAR ARCHITECTURE

All communications to
and from each VSAT is
via the Master Control
Station or Hub

Master Control Station

(The Hub)
VSAT
Community
 VSAT STAR ARCHITECTURE

VSAT

VSAT

Satellite HUB
VSAT

VSAT

VSAT

Topology of a STAR VSAT network viewed from the satellite’s

perspective
Note how the VSAT communications links are routed via the satellite to
the Hub in all cases.
VSAT MESH ARCHITECTURE
• In this network architecture, each of the VSATs
has the ability to communicate directly with any of
the other VSATs.
• Since the traffic can go to or from any VSAT, this
architecture is referred to as a MESH network.
• It will still be necessary to have network control
and the duties of the hub can either be handled by
one of the VSATs or the master control station
functions can be shared amongst the VSATs.
VSAT MESH ARCHITECTURE

VSAT
Community
VSAT MESH ARCHITECTURE
VSAT VSAT

VSAT VSAT

Satellite
VSAT VSAT

VSAT VSAT

VSAT VSAT

Topology of a MESH VSAT network from the satellite’s perspective

Note how all of the VSATs communicate directly to each other via the
satellite without passing through a larger master control station
(Hub).
 ADVANTAGES OF STAR
• Small uplink EIRP of VSAT (which can be a
hand-held telephone unit) compensated for
by large G/T of the Hub earth station
• Small downlink G/T of user terminal
compensated for by large EIRP of Hub earth
station
• Can be very efficient when user occupancy is
low on a per-unit-time basis
 (EIRP)
• In radio communication systems,
Equivalent isotropically radiated power
(EIRP) or, alternatively, Effective
isotropically radiated power is the
amount of power that a theoretical
isotropic antenna (which evenly distributes
power in all directions) would emit to
produce the peak power density observed
in the direction of maximum antenna gain
 G/T (Gain to System Noise
Temperature)
• antenna gain-to-noise-temperature
(G/T): In the characterization of antenna
performance, a figure of merit, where G
is the antenna gain in decibels at the
receive frequency, and T is the
equivalent noise temperature of the
receiving system in kelvins.
DISADVANTAGES OF STAR

• VSAT terminals cannot communicate

directly with each other; they have to
go through the hub
• VSAT-to-VSAT communications are
necessarily double-hop.
• GEO STAR networks requiring
double-hops may not meet user
requirements from a delay perspective
 ADVANTAGES OF MESH
• Users can communicate directly with
each other without being routed via a
Hub earth station
• VSAT-to-VSAT communications are
single-hop
• GEO MESH networks can be made to
meet user requirements from a delay
perspective
DISADVANTAGES OF MESH

• Low EIRP and G/T of user terminals causes

relatively low transponder occupancy
• With many potential user-to-user
connections required, the switching
requirements in the transponder will almost
certainly require On-Board Processing
(OBP) to be employed
• OBP is expensive in terms of payload mass
and power requirements
 How a VSAT can cause interference
to other satellite systems
2o
• In this example, the VSAT is
USAT(2
transmitting to a wanted satellite
2o
WSAT ) (WSAT) but, because the
antenna of the VSAT is small, its
USAT(1
)
beam will illuminate two other
adjacent, unwanted satellites
(USATs) that are 2o away in the
geostationary arc.
Geostationary orbit arc:
satellites at 2o spacing Beamwidth of
VSAT
• In a like manner, signals from
USAT (1) and USAT(2) can be
VSAT received by the VSAT, thus
causing the potential for
interference if the frequencies
and polarizations used are the
same.
 Interference Scenario
WSA
T
Gain, Gw (dB), in
the direction of the
USA wanted satellite
T

Gain of the antenna of the

interfered-with satellite, Gs (dB),
towards the VSAT

Path to the satellite which

will have a fixed path loss Main lobe and
and a variable loss due to first sidelobes of
propagation impairments VSAT antenna

Gain, Gu (dB), in the

direction of the
interfered-with satellite VSAT with an
HPA power of
P (dBW)
 Interference Scenario
•The EIRP of the VSAT towards the interfered-with
satellite [P(dBW) + Gu(dB)] is the interference
power from the VSAT into the interfered-with
satellite.
satellite
• To develop the interference link budget, the Gain
of the interfered-with satellite in the direction of the
VSAT, Gs(dB), would be used, plus any additional
effects along the path (such as site shielding, if used,
expected rain effects for given time percentages, etc.)
 Coding and Modulation
Modulation Scheme:
• High index modulation schemes use bandwidth more
effectively.
• High index modulation schemes also require more link
margin, more amplifier linearity.
• They are also more susceptible to interference and harder
to implement.
• Typically systems work with BPSK or QPSK.
QPSK

Coding Scheme:
• Inner code.
• Outer interleaving code (Reed-Solomon) to protect against
burstiness.
Earth Stations
VSAT Earth Station

• Outdoor Unit (ODU)

• Inter-facility link (IFL)
• Indoor Unit (IDU)
 VSAT Earth Station
• The VSAT Outdoor Unit (ODU) is located where it will have a
clear line of sight to the satellite and is free from casual blockage by
people and/or equipment moving in front of it. It includes the Radio
Frequency Trasceiver (RFT).

• The Inter Facility Link (IFL) carries the electronic signal between
the ODU and the Indoor Unit (IDU) as well as power cables for the
ODU and control signals from the IDU.

• The IDU is normally housed in a desktop computer at the User’s

workstation and consists of the baseband processor units and
interface equipment (e.g. computer screen and keyboard). The IDU
will also house the modem and multiplexer/demultilexer
(mux/demux) units if these are not already housed in the ODU.
VSAT Earth Station - Block
Diagram
Antenna
Feed

LNC DEM Base Band To

IFL
Processor Data
(BBP) Terminal
HPC MOD
Equipment
RFT

Outdoor Unit (ODU) Indoor Unit (IDU)

IDU

RFT

IFL
 VSAT Earth Station – Blocks
Description
• The Low Noise Converter (LNC) takes the received RF signal
and, after amplification, mixes it down to IF for passing over the
inter facility link (IFL) to the IDU.
• In the IDU, the demodulator extracts the information signal from
the carrier and passes it at base band to the Base Band Processor.
• The data terminal equipment then provides the application layer
for the user to interact with the information input. On the
transmit operation, the user inputs data via the terminal
equipment to the baseband processor and from there to the
modulator.
• The modulator places the information on a carrier at IF and this
is sent via the inter facility link to the High Power Converter
(HPC) for upconversion to RF, amplification, and transmission via
the antenna to the satellite.