Scribd
Upload
177 views2 pages

Lift Lug Analysis

The document summarizes the analysis of lift beam materials and components. It provides material properties for ASTM A36 plate and SAE J429 Grade 8 bolts. It also lists dimensions and load allowances for the lug, pin, and welds that connect them, including single and double shear pin strength values over 70,000 lbs. The maximum allowable lug load is 50,347 lbs.

Uploaded by

Tito Febrianto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
177 views2 pages

Lift Lug Analysis

The document summarizes the analysis of lift beam materials and components. It provides material properties for ASTM A36 plate and SAE J429 Grade 8 bolts. It also lists dimensions and load allowances for the lug, pin, and welds that connect them, including single and double shear pin strength values over 70,000 lbs. The maximum allowable lug load is 50,347 lbs.

Uploaded by

Tito Febrianto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
You are on page 1/ 2

Station 5 lift beam Analysis

Materials:
ASTM A36 plate Ftu 58,000 psi SAE J429 Grade 8 Bolt Ftu 150,000
Fy 36,000 Fy 130,000

Lug data: (Values are in inches) Ref: ASME BTH-1-2005 Design of Below-the-Hook Lifting Devices, pages 23, 24

t= 1.25 Lug thickness


a= 2 lug material above the hole
Dh = 2 diameter of hole
Dp = 1.75 pin diameter
R= 2.875 distance form center of hole to plate edge in the direction of the load
be = 1.25 effective width to each side of the pin hole
Nd = 3 minimum design factor

Pt = 50,347 lbs, The allowable tensile strength through the pin hole
beff = 5.000 or
beff = 1.528 or be
Pb = 56,921 lbs, The allowable single plane fracture strength beyond the pin hole
Pb part 1 2.119
Pb part 2 0.708
Pv = 61,126 lbs, The allowable double plane shear strength beyond the pin hole
Av = 5.420 the total area of the two shear planes beyond the pin hole

Lug allowable limit load: 50,347 lbs,

Pin Dp = 1.75 pin diameter SAE J429 Grade 8 Bolt


Pin area = 2.405
Nd = 3 minimum design factor Fr
Pp = 70,154 lbs, Single shear pin strength
2 x Pb = 140,308 lbs, Double shear pin strength

Weld region 60 lift angle


Fv
Weld length in tension= 6.5 total length (in) 2(2 x be + Dh) 46,188 Reaction load (Fr)
fillet eld size = 0.5 23,094 Fh
fillet weld in tension 700 lbs, weld strength per 1/16 fillet (E70 weld wire) 60° 4 d
36,400 lbs Fh 92,376 M
d
Fh
M

40,000
Reaction load (Fr)

You might also like