ROORKEE COLLEGE OF ENGINNERING, ROORKEE

B.Tech. – Electrical &

Electronics Engineering

UNDER THE GUIDANCE OF:

 Mr. I. P. CHANDRA  MR. SANGRAM SINGH BANA
 Mrs. NISHA DHIMAN (EEE & ECE DEPT.)
 Miss PRIYANKA SINGH RANA ROORKEE COLLEGE OF
(EEE & ECE DEPT.) ENGINNERING, ROORKEE
ROORKEE COLLEGE OF
ENGINNERING, ROORKEE

BY – PRASHANT SRIVASTAV
ROLL NO. - 661020108001
 CONTENTS

1. Acknowledgement………………………03
2. Abstract………………………………………04
3. Introduction………………………………. 05
4. Principle……………………………………….05
5. Objective…………………………………….06
6. Scopes………………………………………….10
7. Bibliography…………………………………11

Page 2
 ACKNOWLEDGEMENT

I have taken efforts in this project. However, it would not have been possible
without the kind support and help of many individuals and organizations. I would
like to extend my sincere thanks to all of them.

I am highly indebted to Mr. I.P. CHANDRA, Mrs. NISHA DHIMAN and Miss.
PRIYANKA SINGH RANA for their guidance and constant supervision as well as
for providing necessary information regarding the project & also for her support in
completing the project.

I would like to express my gratitude towards my parents & member of ROORKEE

COLLEGE OF ENGINEERING, ROORKEE for their kind co-operation and
encouragement which help me in completion of this project.

I would like to express my special gratitude and thanks to industry persons for
giving me such attention and time.

My thanks and appreciations also go to my colleague in developing the project

and people who have willingly helped me out with their abilities.

Page 3
 ABSTRACT
Although RTL stays away from all these logic families, it is still interesting to see if
there is some connection between them... some common general idea... Let’s try
to find it...
Remember that in RTL we summed voltages by converting them to currents. But
this circuit was sensitive to the magnitudes of the voltages and resistances; in
addition, the number of inputs was limited. It seems we can sum, besides voltages
and currents, why not resistances as well?
Here is the implementation.
The input logic variables turn on (at logic "1") or turn off (at logical "0") equal
reference resistances (conductance).They are summed by an analog summer
again.
Their sum is converted to voltage and compared by a threshold device (voltage
comparator) whose threshold is lower than one reference. So it is sufficient that
only one reference is turned on and the output is set at logic state "1".

This idea is taken to the extreme in the classic DL, DTL, TTL, MOS and CMOS
circuits where the reference resistances are increased up to infinity. In practice,
they are implemented by diode or transistor switches operated by the logic input
variables.
They are connected in series to sum the switch resistances or in parallel to sum
their conductance (DL, DTL and TTL use only a parallel connection).

Page 4
 Introduction
A gate is defined as a digital circuit which follows some logical relationship
between the input and output voltages. It is a digital circuit which either allows a
signal to pass through as stop, it is called a gate. The logic gates are building
blocks at digital electronics. They are used in digital electronics to change on
voltage level (input voltage) into another (output voltage) according to some
logical statement relating them. A logic gate may have one or more inputs, but it
has only one output. The relationship between the possible values of input and
output voltage is expressed in the form of a table called truth table or table of
combinations. Truth table of a Logic Gates is a table that shows all the input and
output possibilities for the logic gate. George Boole in 1980 invented a different
kind of algebra based on binary nature at the logic, this algebra of logic called
BOOLEAN ALGEBRA. A logical statement can have only two values, such as
HIGH/LOW, ON/OFF,CLOSED/OPEN, YES/NO, RIGHT/WRONG,
TRUE/FALSE,CONDUCTING/NON-CONDUCTING etc. The two values oflogic
statements one denoted by the binary number 1 and 0.The binary number 1 is
used to denote the high value. The logical statements that logic gates follow are
called Boolean expressions

PRINCIPLE:

Any Boolean algebra operation can be associated with inputs and

outputs represent the statements of Boolean algebra. Although these
circuits may be complex, they may all be constructed from three basic
devices. We have three different types of logic gates. These are the
AND gate, the OR gate and the NOT gate.

Logic states
High low
1 0
+v 0v
On Off
Close open
Right wrong
Page 5
 True false
Yes no
Objective – To implement the logic NAND
gate using NPN transistor.
Components Required –

 BREADBOARD
A breadboard is a solder less device for temporary prototype with
electronics and test circuit designs. Most electronic components in electronic
circuits can be interconnected by inserting their leads or terminals into the
holes and then making connections through wires where appropriate. The
breadboard has strips of metal underneath the board and connect the holes
on the top of the board. The metal strips are laid out as shown below. Note
that the top and bottom rows of holes are connected horizontally and split in
the middle while the remaining holes are connected vertically.

 RESISTORS
A resistor is a passive two-terminal electrical component that implements
electrical resistance as a circuit element. In electronic circuits, resistors are
used to reduce current flow, adjust signal levels, to divide voltages, bias
active elements, and terminate transmission lines, among other uses. High-
power resistors that can dissipate many watts of electrical power as heat,
may be used as part of motor controls, in power distribution systems, or as
test loads for generators. Fixed resistors have resistances that only change
slightly with temperature, time or operating voltage. Variable resistors can
be used to adjust circuit elements (such as a volume control or a lamp
dimmer), or as sensing devices for heat, light, humidity, force, or chemical
activity.

Page 6
  LED (LIGHT EMITTING DIODE)
A light-emitting diode (LED) is a two-lead semiconductor light source. It is a p–n
junction diode that emits light when activated. When a suitable current is applied
to the leads,
Electrons are able to recombine with electron holes within the device, releasing
energy in the form of photons. This effect is called electroluminescence, and the
color of the light (corresponding to the energy of the photon) is determined by the
energy band gap of the semiconductor. LEDs are typically small (less than 1
mm2) and integrated optical components may be used to shape the radiation
pattern.

 NPN TRANSISTOR(BC548)
The BC548 is a part of a family of NPN and PNP epitaxial silicon transistors that
originated with the metal-cased BC108 family of transistors. This series,
introduced in 1966 by Philips, became the most used transistors in Australia and
was taken up by many European manufacturers. The BC548 is the modern
plastic-packaged BC108 the BC548 article at the Radiomuseum website
describes the BC548 as a successor to the BC238 and differing from the BC108
in only the shape of the package. Datasheets for the BC548 give specifications
that are identical to, or exceed, those of the BC108, BC148 and BC238
predecessors. Thus the BC548 (or BC546 to 550) is a valid substitute in any
circuit designed for the older BC108 (or BC148), which includes many Mullard and
Philips published designs. citation needed
As of 2016, the BC548 is principally produced by ON Semiconductor and Fairchild
Semiconductor.

Page 7
  VOLTAGE REGULATION IC 7805
78xx (sometimes L78xx, LM78xx, MC78xx...) is a family of self-contained fixed
linear voltage regulator integrated circuits. The 78xx family is commonly used in
electronic circuits requiring a regulated power supply due to their ease-of-use and
low cost.

Circuit Details :-

Page 8
Concept about NAND GATE :-

The NAND (Not – AND) gate has an output that is normally at logic level “1” and only
goes “LOW” to logic level “0” when ALL of its inputs are at logic level “1”. The Logic
NAND Gate is the reverse or “Complementary” form of the AND gate.
The logic or Boolean expression given for a logic NAND gate is that for Logical
Addition, which is the opposite to the AND gate, and which it performs on
the complements of the inputs. The Boolean expression for a logic NAND gate is
denoted by a single dot or full stop symbol, ( . ) with a line or Overline, ( ‾‾ ) over the
expression to signify the NOT or logical negation of the NAND gate giving us the
Boolean expression of: A.B = Q.
Then we can define the operation of a 2-input digital logic NAND gate as being:

“If either A or B are NOT true, then Q is true”

TRANSISTOR NAND GATE –

A simple 2-input logic NAND gate can be constructed using RTL Resistor-transistor
switches connected together as shown below with the inputs connected directly to
the transistor bases. Either transistor must be cut-off “OFF” for an output at Q.

Page 9
Logic NAND Gates are available using digital circuits to produce the desired logical
function and is given a symbol whose shape is that of a standard AND gate with a
circle, sometimes called an “inversion bubble” at it’s output to represent
the NOT gate symbol with the logical operation of the NAND gate given as.

SCOPES: BIOLOGICAL LOGIC GATES FOR

BIOLOGICAL COMPUTERS

DNA is often referred to as the building block of life. Now scientists from Imperial
College London have demonstrated that DNA (and bacteria) can be used to create
the fundamental building blocks of a computer - logic gates. Using DNA and
harmless gut bacteria, the scientists have built what they claim are the most
advanced biological logic gates ever created by scientists. The research could lead
to the development of a new generation of microscopic biological computing devices
that, amongst other things, could travel around the body cleaning arteries and
destroying cancers.

While previous research had already proven biological logic gates could be made,
the Imperial College scientists say the big advantage of their creations is that they
behave like their electronic counterparts - replicating the way that electronic logic
gates process information by either switching "on" or "off." Importantly, the new
biological logic gates are also modular, meaning they could be fitted together to
make different types of logic gates and more complex biological processors.

To create a type of logic gate called an "AND gate," the team used modified DNA to
reprogram Escherichia Coli (E.Coli) bacteria to perform the same switching on and
off process as its electronic equivalent when stimulated by chemicals. In a similar
way to the way electronic components are made, the team demonstrated that the
biological gates could be connected together to form more complex components.

Page 10
The team also created a "NOT gate" and combined it with the AND gate to produce
the more complex "NAND gate." NAND gates are significant because any Boolean
function (AND, OR, NOT, XOR, XNOR), which play a basic role in the design of
computer chips, can be implemented by using a combination of NAND gates.

The researchers will now try and develop more complex circuitry that comprises
multiple logic gates. To accomplish this they will need to find a way to link multiple
biological logic gates together that is similar to the way in which electronic logic gates
are linked together to enable complex processing to be carried out.

"We believe that the next stage of our research could lead to a totally new type of
circuitry for processing information," said Professor Martin Buck from the Department
of Life Sciences at Imperial College London. "In the future, we may see complex
biological circuitry processing information using chemicals, much in the same way
that our body uses them to process and store information."

The team also suggests that these biological logic gates could one day form the
building blocks of microscopic biological devices, such as sensors that swim inside
arteries, detecting the build up of harmful plaque and rapidly delivering medications
to the affected area. Other sensors could detect and destroy cancer cells inside the
body, while others could be deployed in the environment to monitor pollution and
detect and neutralize dangerous toxins.

BIBLIOGRAPHY
 www.electronicstutorials.com
 www.wikipedia.com
 https://www.newatlas.com/biological-logic-gates/20237/

Page 11