1.

Single Site Verification

Site Information
Region Cox's Bazar
Site Name UB3824
Site Address With PIN Code
Site ID UB3824
Node Type DBS3900
RNC RNCT01
Longitude (Decimal) 91.98079
Latitude (Decimal) 21.44257
Cluster ID(Name) Cox's Bazaar Cluster 1
Tower Type Tower
Test date 8-Jan-15
Tester Name Kaium
Tower Height 12m

2.CELL DATA

Remarks Huawei
Stationary Check Sector 1 Sector 2 Sector 3
and Airtel

Azimuth 60 180 300

Electrical Down Tilt 2 2 2
Mechanical Tilt 0 0 0
Antennas Height (Mrt.) 28m 28m 28m
Antenna Make & Model Single Band (Standard_A19451811) Single Band (Standard_A19451811) Single Band (Standard_A19451811)
Cell Id 13824 23824 33824
VSWR
SC 8 16 24
CPICH RSCP -78.33 -70.49 -71.03
CPICH Ec/No -5.03 -4.49 -4.73
20 to 50m from
Distance from Site 413m 164m 95m
site

3. General Check for RF Performance by Mobile (Stationary Test)

Activity / Process Target Remark Cell 1 Cell 2 Cell 3 Remarks Huawei and Airtel
Frequency and Scrambling Code correctly defined (Y/N) Y Y Y
The LAC/RAC is correctly defined (Y/N) Y Y Y
Cell selection parameters is planned (Y/N) Y Y Y
Idle
All IRAT & Handover Parameter definition as per Plan(Y/N) Y Y Y checked from OMC
The neighbor list and parameters are as planned (Y/N) Y Y Y
Cable Swap Check(Y/N) Y Y Y
AMR Call (10 calls each)
Call Originating - Mobile to Mobile (Y/N) Y Y Y
Call Terminating - Mobile to Mobile (Y/N) Y Y Y
MOS (AMR Voice) >=3.5
CS 12.2 kbps voice AMR, call set up time < 6 sec 1.45 1.44 1.42
Video Call (10 calls each)
Video Call Originating - Mobile to Mobile (Y/N) Y Y Y
Video Call Terminating - Mobile to Mobile (Y/N) Y Y Y
need to check how
RAB Establishment Test: PS 64 (Y/N) to get this KPI from
signalling
need to check how Need to check from Field and
RAB Establishment Test: PS 128 (Y/N) <=3 secs for 95% & <=6 for 100% Average <3s to get this KPI from OMC if possible it will icluded
signalling else this KPI will leave out.
need to check how
RAB Establishment Test: PS 384 (Y/N) to get this KPI from
signalling
Peak Throughput DL( HSDPA) 18Mbps 16M CQI>29 ,64QAM 10368 9263 11911
Peak Throughput UL( HSUPA) 4.2Mbps 4M 1884 1983 1949

Dedicated need to check how

Average throughput PS64 55 Kbps to get this KPI from
signalling
need to check how
Average throughput PS128 110 Kbps to get this KPI from
signalling
need to check how
Average throughput PS384 330 Kbps to get this KPI from
signalling

CQI 27
5 codes – 5.0Mbps 5 code 5M
Peak throughput HSDPA (HSPA+) 10 codes – 12.0Mbps 10368 9263 11911
10 code 8M
15 codes – 18.0 Mbps 15 code 10M Through put will check only for
defined Code
a) 5 codes – 1.4Mbps 1Mbps (Cat 3 )
peak throughput HSUPA (HSPA+) b) 10 codes – 2.7Mbps 1.7Mbps(Cat 5 ) 1884 1983 1949
c) 15 codes – 4Mbps 3.3Mbps(Cat 6 )
<= 5 Sec, for >=98% of Long Ping;<= 150 average <5s
Latency test for All R99 RAB’s in short & long ping
mSec, for >=98% of Short Ping
As per project procedure no test was done Need to be checked from filed
Latency test for HSDPA & HSUPA in short & Long ping <= 4.40 Sec for Long ping & < = 50ms for average <4.4s
short Ping, for >=98% of Ping

OEMs to produce all necessary logs for above mentioned tests

Note:- on requirement.

4.DRIVE TEST within Cell Coverage Area

Remarks Huawei
Key Performance Indicator Test Method Description Target Review Result
and Airtel
Setup Success Rate
3G CS (12.2 kbps voice AMR & 64K Video) - Drive Test Call Setup Success Rate 98% 100%
- At least 200 samples

PDP Context setup Success Rate 10 calls/cell

a) DCH for R99
- Drive Test 99% for DU & U
HSDPA & PS Context Activation - At least 200 samples b) HS-DSCH for HSDPA 97% for SU & Rural 100%

- Drive Test PDP Context Setup Success Rate 99% for DU & U
HSUPA PDP Activation - At least 200 samples a) E-DCH for HSUPA 97% for SU & Rural 100%

per site and depends

Drop Call Rate on attempted

a) Drive Test per site and depends

3G CS (12.2 kbps voice AMR & CS64K Video call) Drop Call Rate <2% 0%
on attempted

Retainbility a) Drive Test need check from field

PS/HS Drop call rate Drop Call Rate <2% 0% and per 10 attems
from sites.
As per project
procedure no test
Multiple 100 byte pings (min 100 pings < 0.15s was done need check from field
3G PS Data Latency( Continuous) attempt) Latency( Continuous) R99/ HSPA (HSDPA+HSUPA): and per 10 attems
from sites.

CellA:1.45sec
Service Access Time CS Drive Test:Voice Service Access Time Voice < 6 Sec CellB:1.44sec
CellC:1.42sec
CellA:10368
Download Throughput at cell edge
DL Cell Edge Throughput > = 512 Kbps CellB:9263
@ 50% DL load
CellC:11911
Test will do for
Drive test in the Cell Coverage Area Uplink Throughput at cell edge @
> = 64 Kbps CellA:1884 normal load.
50% UL Load
UL Cell Edge Throughput CellB:1983
Integrity Uplink Throughput at cell edge @ CellC:1949
> = 128 Kbps
35% UL Load
As per project
DL BLER shall be reported by the UE
DL CS BLER (CS64) Drive Test:Voice <=1.5% procedure no test
according to 3GPP specifications.
was done

There is no 3G-2G SGSN and GGSN KPI,

Packet Switch 3G->2G Cell Change service interupt can not check from
3G-2G Service Interrupt Time Drive Test Interruption Time <=10 s time as directly DT. Leave out this
handover to 3G KPI

Formula: Packet drop =PS Session

Packet Drop Driver Test drop times/PDP active succes times. <1% 0%
(drive test)

Packet Retransmission Driver Test Through Drive Test, on TCP/IP layer <0.5% 0%

a) Field Survey (Drive Test)

3G to 2G allow but
b) Across 2G/3G transition area (3G
Voice 3G-2G (Both ways) iRAT 2g to 3g not allow.
Voice 3G-2G HO (Both ways) network to/from 2G network) Success Rate >=98.5% 3G to 3G HO
Handover Success Rate Air tel will confirm
c) Minimum 20 attempts the HO strategy.

a) Field Survey (Drive Test)

3G --> 2G IRAT CELL CHANGE(HSDPA) b) PDP activated PS Hard Handover Success Success Rate >=97% This is not allowed Airtel will confirm
c) FTP download Rate( Both ways 3G-2G & 2G-3G)) now

a) Field Survey (Drive Test)

b) Good RF condition with Received
Signal Code Power, RSCP > -90dBm and Now not Valid, as
Ec/No > - 12 dB. For 2G radio network, single Frequency
3G/2G, 3G Inter-frequency Transition Good RxLev > -85dBm and RxQual <5 3G to 2G,3G Inter-frequency Idle Success Rate >=97% will be exist For No need check.
Mode re-selection success rate Leave out this KPI
c) Meeting defined thresholds in SIB3 this project not
and SIB11 vsalid..
d) Minimum 40 attempts for each test
Mobility

a) Field Survey (Drive Test)

b) Idle Mode
c) 3G cell re-selction from 2G, in idle 2G-3G cell re-
2G-3G cell re-selection Idle Mode, iRAT cell re-selection < 4 sec 2 sample/ sector
mode after voice call release in 2G selection
d) At least 20 samples should be
collected
1.RSCP
RSCP Plot

2.EC/Io
Ec/No Plot

3.HSDPA Throughput
HSDPA Throughput

4.1 Modulation Scheme Usesd(QPSK) 4.2 Modulation Scheme Usesd(16QAM) 4.3 Modulation Scheme Usesd(64QAM)
Modulation Scheme-QPSK Modulation Scheme-16QAM Modulation Scheme-64QAM

5. Pilot Best Server(PSC)

PSC Google earth pic

Two sites are vrey close area