MATHEMATICAL RECREATIONS

by Ian Stewart

shape, you get a square cross section.

Cone with a Twist Unlike all other rhombuses, the square
has an extra symmetry: rotate it through
a right angle and it fits back into the

T he cone is probably most fa-

miliar today as an edible con-
tainer for ice cream, but its
past glories lie in higher realms alto-
gether. The geometry of the cone was
an angle and constructing a cube with
twice the volume of a given cube. Both
reduce to solving an equation of the
third degreethat is, one in which the
highest exponent of the variable is
same shape. So you can slice such a
double-cone down the middle, rotate
one of the halves through a right angle
and glue the two pieces back together.
This is the sphericon. Thanks to the
known to the ancient Greeks, mainly three. Conic sections can be used to twist, it is not a double-cone but a
because of the elegant curves that could solve the problems because the points much more interesting beast. I'd never
be constructed by slicing a cone with a where two sections meet correspond to seen such a shape mentioned anywhere
plane. The Greeks delighted in the intri- solutions of equations of the third and before, but if Im wrong about its nov-
cate geometry of these conic sections fourth degrees. In contrast, rulers and elty Im sure that a better-informed
the ellipse, parabola and hyperbola compasses can solve only second-degree reader will quickly tell me.
and discovered how to use them to equations. The sphericon can be made from a
solve problems that were beyond the The cone itself has generally been of single piece of thin card, cut to a shape
reach of rulers and compasses. less interest to mathematicians than its made from four identical sectors of a
Those problems included trisecting planar sections, perhaps because the circle joined together so that they face
cone is so simple in form. Is there any- in alternate directions [see illustration
thing new to say about this humble on opposite page]. The main calcula-
solid? Indeed there is. In May 1999 C. tion involved in designing this shape is
J. Roberts, a reader of this column who to find the angle between the two
lives in the English town of Baldock, straight edges of the sector. Suppose the
wrote to me about a very curious shape length of each edge is 1. If the double-
that he calls a sphericon. He even en- cone has a square cross section, the
closed two of them in his letter. Pythagorean theorem says the base of
The sphericon [see illustration below] each component cone has a diameter of
is a double-conetwo identical cones 2 . So the circumference of the base is
joined base to basebut with a twist. It 2 . The length of the sectors arc is
is easy to make. If you slice a double- half that (because you cut the double-
cone along a plane that includes both cone in half to make a sphericon). The
vertices, you get a rhombic cross sec- angle of the sector therefore works out
tion, a parallelogram with four equal to be 2 2 radians, or 90 2 degrees,
sides. If you use cones of just the right which is approximately 127.28 degrees.

TO CONSTRUCT A SPHERICON
join two cones at the base (a), then cut along
the plane that includes the vertices (b). Rotate one half
90 degrees (c), then glue the halves together (d).

116 SCIENTIFIC AMERICAN October 1999 Mathematical Recreations

 ing a solid whose outer surface consists
of a single curved face. This shape, how-
ever, has a hole in the middle: it is a ring.
Does there exist a solid that is not a ring
whose outside has a single curved face?
One day, while Roberts was working on
a length of wood with a square cross
section, he started thinking about blend-
ing one face into the next by planing a
curve around the ends. Do this at both
ends, eliminate the wood in between,
and you get a sphericon.
He made one out of mahogany and
gave it to his sister, who has kept it ever
If you cut out the shape shown in the cube and join the dots by straight lines, since. Then he forgot the topic until
illustration, you can roll up the sectors you get an octahedron. And cubes, of 1997, when I gave a series of televised
into half-cones and glue the tab to the course, stack in a regular manner to mathematics lectures and talked about
matching edge. With a little adjustment form a flat layer or fill three-dimen- symmetry. At that point Robertss inter-
the bases of the half-cones will fit snugly sional space. est was revived, and he wrote to me.
with no gap, and you can tape the joins. Roberts, who is 47, invented the If two sphericons are placed next
The first delight of the sphericon is: it sphericon about 30 years ago. Geometry to each other, they can roll on each others
rolls! A cone placed on a flat surface was his strong point at school, and he surfaces. Four sphericons arranged in a
rolls around in circles. A double-cone started work as a joiners apprentice. Not square block can all roll around one an-
can roll in a clockwise circle or a coun- surprisingly, therefore, his first sphericon other simultaneously. And eight
terclockwise one, but it rolls straight was carved out of wood. His starting sphericons can fit on the surface of one
only if you rapidly bowl it or set it on point was the well-known Mbius strip, sphericon so that any one of the outer sol-
rails. A sphericon performs a controlled a band of paper joined end to end with a ids can roll on the surface of the central
wiggle, which on average is straight. 180-degree twist. Roberts realized that one.
First one conical sector is in contact with because paper has a definite thickness, The possible arrangements of
the flat surface, then the next. So as it the bands cross section is really a long, sphericons seem endless. I leave to readers
moves forward it wiggles alternately to thin rectangle. If you make the cross sec- the pleasure of playing with this extremely
the left and right. It is especially inter- tion into a square, you can join the ends clever mathematical toy and inventing new
esting to start it at the top of a gradual with a 90-degree twist instead, produc- patterns for themselves. SA
slope and watch it wobble its way down.
After reading the letter from Roberts, I
spent a pleasant half-hour with several
other mathematicians rolling sphericons
along a table.
The letter also hinted at some of the
sphericons fascinating attributes: it has
one continuous face, and one sphericon
can roll around another ad infinitum.
Intrigued, I asked for more information,
and in return Roberts sent an enormous
cardboard box that weighed virtually
nothing. It contained a large lattice of
about 50 sphericons, neatly assembled
with transparent tape. This lattice, like
the atomic lattice of a crystal, repeats
indefinitely in three dimensions.
One reason why the sphericon has
such neat geometric properties is that its
four edgesthe lines where the com-
ponent sectors meetlie along four of the
edges of a regular octahedron. The
other four edges of the octahedron cor-
respond to lines that bisect the vertex
angles of the sectors. The octahedron, in
turn, is closely related to the cube: if you
put a dot in the middle of each face of a

Mathematical Recreations