Scribd
Upload
43 views

HW12

HW 12

Uploaded by

Harvin Waraich
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
43 views

HW12

HW 12

Uploaded by

Harvin Waraich
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 2
9.99 A refrigerator has a steady flow of R-410A as saturated vapor at ~20°C into the adiabatic compressor that brings it to 1400 kPa. After the compressor, the temperature is measured to be 60°C. Find the actual compressor work and the actual cycle coefficient of performance. 9.160) Consider an ideal steam regenerative cycle in which steam enters the turbine at 600 Ibf/in.?, 700 F, and exhausts to the condenser at 2.225 Ibflin.. Steam is extracted from the turbine at 150 Ibf/in.? for an open feedwater heater. The feedwater leaves the heater as saturated liquid. The appropriate pumps are used. for the water leaving the condenser and the feedwater heater. Calculate the thermal efficiency of the cycle and the net work per pound-mass of steam. 9.171) A refrigerator receives 500 W of electrical power to the compressor driving the cycle flow of R-134a. The refrigerator operates with a condensing temperature of 100 F and a low temperature of -10 F. Find the COP for the cycle and its cooling capacity. 10.64 10.90 A4 stroke gasoline engine runs at 1800 RPM with a total displacement of 3L and a compression ratio of 10:1. The intake is at 290 K, 75 kPa with a mean effective pressure of 600 kPa, Find the cycle efficiency and power output. A diesel engine has a state before compression of 95 kPa, 290 K, and a peak pressure of 6000 kPa, a maximum temperature of 2400 K. Find the volumetric compression ratio and the thermal efficiency. 10.143) A large stationary Brayton cycle gas-turbine power plant delivers a power output of 100 000 hp to an electric generator. The minimum temperature in the cycle is 540 R, and the exhaust temperature is 1350 R. The minimum pressure in the eyele is 1 atm, and the compressor pressure ratio is 14 to 1. Calculate the power output of the turbine, the fraction of the turbine output required to drive the compressor and the thermal efficiency of the cycle? 10.168) 560 R and the total cycle efficiency is 1 = 2/3. Find T,,, the specific work and volume ratio in Air ina piston/cylinder goes through a Camot cycle in which T, the adiabatic expansion for constant Cp, Cy.

You might also like