Scribd
Upload
173 views

Haltech Can Connector

This document provides information about connecting a Haltech Platinum Sport Series 1 & 2 rear CAN connector, including pin functions and whether a terminating resistor is required. It explains that pin 1 is ground, pin 4 is 12V out, pin 7 is CAN HI, and a 120 ohm terminating resistor should be connected if the ECU is at the end of the CAN bus but left open if it is in the middle. It includes a diagram showing an example CAN bus topology and where terminating resistors are needed.

Uploaded by

gustavoportilla
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
173 views

Haltech Can Connector

This document provides information about connecting a Haltech Platinum Sport Series 1 & 2 rear CAN connector, including pin functions and whether a terminating resistor is required. It explains that pin 1 is ground, pin 4 is 12V out, pin 7 is CAN HI, and a 120 ohm terminating resistor should be connected if the ECU is at the end of the CAN bus but left open if it is in the middle. It includes a diagram showing an example CAN bus topology and where terminating resistors are needed.

Uploaded by

gustavoportilla
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

HALTECH PLATINUM SPORT SERIES 1 & 2

REAR CAN CONNECTOR

SERIES IS KNOWN BY LAST DIGIT ON SERIAL NUMBER OF UNIT

Pin # Function
1 Ground
2 Reserved
3 CAN LO
CONNECT 120 OHM TERMINATING RESISTOR IF REQUIRED.
4 12V Out TERMINATING RESISTOR WILL BE REQUIRED IF ECU
5 Reserved IS AT THE END OF A CAN BUS,
LEAVE OPEN IF ECU IS IN THE MIDDLE OF A CAN BUS
6 Reserved SEE EXAMPLE
7 CAN HI
8 Reserved

TERMINATING RESISTOR EXAMPLE

Device Device
1 4
Terminating CAN BUS Terminating
4 3 2 1
Resistor Resistor
8 7 6 5 Required Required

LOCK
CRIMP PIN TO WIRE AND THEN INSERT INTO BACK OF PLUG Device Device
WITH THE PIN LOCKING TAB IN THE UNLOCK POSITION. UN-LOCK 2 3
PUSH DOWN TO LOCK PIN IN PLACE Terminating Terminating
Resistor Resistor
Not Required Not Required

HALTECH CAN CONNECTOR


HALTECH, SYDNEY AUSTRALIA
DATE: 4TH MAY 2009
REV C SHEET 1 OF 1

You might also like