Scribd
Upload
5K views1 page

JSA - Changing Light Bulbs

This document provides a job safety analysis for changing light bulbs or tube lights. It breaks the job down into 3 steps and identifies potential hazards at each step such as electric shock, slips and falls, cuts from broken glass. It also lists the controls that are in place to mitigate the hazards, such as lockout/tagout procedures, using proper tools, and inspecting equipment. Responsibilities for ensuring controls are followed are assigned to the electrician. The final step is to discuss which lifesaving rules apply to the job.

Uploaded by

Ashok Suresh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
5K views1 page

JSA - Changing Light Bulbs

This document provides a job safety analysis for changing light bulbs or tube lights. It breaks the job down into 3 steps and identifies potential hazards at each step such as electric shock, slips and falls, cuts from broken glass. It also lists the controls that are in place to mitigate the hazards, such as lockout/tagout procedures, using proper tools, and inspecting equipment. Responsibilities for ensuring controls are followed are assigned to the electrician. The final step is to discuss which lifesaving rules apply to the job.

Uploaded by

Ashok Suresh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Job Safety Analysis Form

JSA #: Prepared by:

Procedure Reference: Reviewed & Approved by:

Job Description: Changing Light Bulbs/Tube light Unit Name: Date:

Responsibilities:
Tasks: Break the job Hazards: What hazards did you find for
Step Controls: Who will be
down into a logical each task?
# What controls are in place or will you put in place? responsible for each
sequence of steps
of those controls?
Arrange new
bulbs/tubes including Wrong bulb/Tube (Substandard, different Pre use inspection for bulbs/tubes to be performed along with tools
Electrician
tools required for connection, different capacity)
1 change Defective tools
Finger pinched while opening light cover Proper hand and body placement and keep hand clear from pinch point Electrician
for replacement of bulb/tube light while opening the cover.
Electric shock while changing bulb/tube Lockout the light to be worked on as per LOTO procedure.
light Use proper tools for removing lenses and covers.
Slips and fall while using portable ladder Secure the ladder on firm & non slippery surface to avoid slip & fall.
Change the light bulbs Cut lacerations if broken glass. Reassembly light correctly.
2 or tube Burns Incase old bulb/tube is hot
Double check connections & tightness of light replaced. Electrician
Follow LOTO procedure for De-isolation for light.
3 Turn on Lights. Short circuit/loose connections

Tick and discuss


the lifesaving rules
which are related
to the job during
meeting

You might also like