Scribd
Upload
43 views

Firmware Upgrade Procedure

This document provides instructions for upgrading the firmware on Trendnet TV-IP751WC, TV-IP751WIC, TV-IP851WC, and TV-IP851WIC cameras. It notes that a wired connection and avoiding interruptions are required. The steps are to download the firmware file, log into the camera's web interface, select the file and click upgrade, check that the upgrade completed successfully, perform a factory reset, and then restore settings from a backed up file if desired.

Uploaded by

Ulices Perez Reyes
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
43 views

Firmware Upgrade Procedure

This document provides instructions for upgrading the firmware on Trendnet TV-IP751WC, TV-IP751WIC, TV-IP851WC, and TV-IP851WIC cameras. It notes that a wired connection and avoiding interruptions are required. The steps are to download the firmware file, log into the camera's web interface, select the file and click upgrade, check that the upgrade completed successfully, perform a factory reset, and then restore settings from a backed up file if desired.

Uploaded by

Ulices Perez Reyes
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

TV-IP751WC / TV-IP751WIC / TV-IP851WC / TV-IP851WIC

Camera Firmware Upgrade Procedures


Warning:

Always upgrade firmware with a wired connection.


Do not interrupt the connection while doing the firmware upgrading
Save your configuration before firmware upgrade

Note:

1) TV-IP751WC is used for below procedures; other cameras follow the similar route.

2) It is necessary to perform a factory reset after the firmware upgrade. If you would like to keep
your original setting, please back up your configuration first prior to upgrade the firmware as
instructed at the last page.

Firmware Upgrade
1. Download and unzip the firmware file from www.trendnet.com/downloads . Save the firmware on
your computer. The firmware file name ends with *.bin.

2. Open a browser and go to your cameras IP address: to find the camera IP, please use the Setup
Wizard, on the CD-ROM under the menu folder (default is 192.168.10.30, without a DHCP server.)

3. Enter the username & password (By default, the username & password is admin/admin, or enter the
password setup by you.)

-1-
4. Go to Administration page, Tools tab then Firmware Upgrade option

Click Browse to select the new firmware file then click Upgrade.

5. Firmware upgrade completed.

-2-
6. After reboot, click Status/System tab again to check the new firmware version.

7. After firmware upgrade, please click factory reset

8. Your firmware upgrade is now completed. To find the camera IP, please use the Setup Wizard (can
be found on the CD-ROM) to search and configure your camera again.

9. Back up
To keep your original settings prior to the firmware upgrade, please back up the config.cfg file and
save the file to your chosen folder before the firmware upgrade starts.

Restore
After the firmware upgrade completed, then Restore the config.cfg file and your original settings will
be restored.

-3-
-4-

You might also like