Scribd
Upload
62 views

Tutorial Sheet: 01: 1. Determine The Output Voltage in Following Circuit

This document contains a tutorial sheet with 10 practice problems for determining voltages and characteristics in basic electronic circuits using operational amplifiers and other components. The problems involve calculating output voltages, voltage gains, maximum input frequencies and voltages across resistors for various circuits involving op-amps, resistors and capacitors.

Uploaded by

Mr. Praveer Saxena
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
62 views

Tutorial Sheet: 01: 1. Determine The Output Voltage in Following Circuit

This document contains a tutorial sheet with 10 practice problems for determining voltages and characteristics in basic electronic circuits using operational amplifiers and other components. The problems involve calculating output voltages, voltage gains, maximum input frequencies and voltages across resistors for various circuits involving op-amps, resistors and capacitors.

Uploaded by

Mr. Praveer Saxena
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Tutorial Sheet : 01

Subject Basic Electronics Subject Code REC-201

1. Determine the output voltage in following circuit:

2. Determine the voltage gain of following circuit:

3. Determine the output voltage in the following circuit.

4. In the following circuit determine the output voltage:


5. Design a circuit using operational amplifier which satisfies following equation: V out = 4V1
5V2
6. Determine the output voltage in following circuit:

7. Determine the output voltage in the following circuit. Given V1 = 4V and V2 = 8V


respectively.

8. Determine the voltage across resistor RLOAD in following figure.

9. Calculate the maximum frequency of the input signal for the below circuitof fig. A,
where SR=0.5V/sec.
10. If Input to a differentiator is 5Sint. What is the maximum frequency we can applied to
input of op-amp that will result in undistorted output? If the value of resistance used is
10K and capacitor is 10F of Given Slew rate is 10V/micro-second.

You might also like