Scribd
Upload
167 views1 page

RS232 Support: CNC: Fanuc 3 CNC Parameters

Set the machine's mode dial to MDI. Go to the parameter screen and change parameters 5/14 such that Bit 0 = 0. Change parameters 68/69 to 4800. Also set ISO to 1 on the Settings screen with an IO channel of 0 or 1. Reset the machine and power cycle it. For PC DNC settings, use 4800 baud, 7 data bits/ASCII Even code, 1 stop bit, LF EOB, XON/XOFF handshaking, %LF leader and % trailer with skipping of lines containing %. To output a program from the PC, ensure being in EDIT mode then press PROGRM, Oxxxx and START.

Uploaded by

Nguyễn Khắc Lợi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
167 views1 page

RS232 Support: CNC: Fanuc 3 CNC Parameters

Set the machine's mode dial to MDI. Go to the parameter screen and change parameters 5/14 such that Bit 0 = 0. Change parameters 68/69 to 4800. Also set ISO to 1 on the Settings screen with an IO channel of 0 or 1. Reset the machine and power cycle it. For PC DNC settings, use 4800 baud, 7 data bits/ASCII Even code, 1 stop bit, LF EOB, XON/XOFF handshaking, %LF leader and % trailer with skipping of lines containing %. To output a program from the PC, ensure being in EDIT mode then press PROGRM, Oxxxx and START.

Uploaded by

Nguyễn Khắc Lợi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

CNC: Fanuc 3

RS232 Support

CNC Parameters
Set parameter input enable switch to enabled. This switch can
be found inside the machine's cabinet on the main printed circuit
board.
Set the machine's mode dial to MDI.
Go to the parameter screen. Change parameters 5/14 such that
Bit 0 = 0. Change parameters 68/69 to 4800.
Also of note, you will want to make sure ISO is set to 1 on the
Settings screen, with an IO channel of 0 or 1.
Set parameter input enable switch to disable. Reset the
machine. Power it off, then on again.

PC DNC Settings
Baud: 4800
Code: 7 data bits / ASCII Even
Stop Bits: 1
EOB: LF
Handshaking: XON/XOFF
ADVANCED
Leader: %LF
Trailer: %
Skip lines which contain: %

Additional Notes

To output a program, make sure you are in EDIT mode. Press


PROGRM, Oxxxx then START (output).

You might also like