Scribd
Upload
128 views

Differential Protection of Transformer Differential Relays

Differential protection is commonly provided for power transformers rated over 5MVA. Differential relays can detect faults inside the transformer that Buchholz relays may miss, such as flashovers at bushings. Differential relays also respond faster to internal faults than Buchholz relays. Differential protection works by comparing the primary and secondary currents of the transformer - under normal operation the currents oppose each other, but a fault causes an imbalance that triggers the relay.

Uploaded by

HARIHARAN
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
128 views

Differential Protection of Transformer Differential Relays

Differential protection is commonly provided for power transformers rated over 5MVA. Differential relays can detect faults inside the transformer that Buchholz relays may miss, such as flashovers at bushings. Differential relays also respond faster to internal faults than Buchholz relays. Differential protection works by comparing the primary and secondary currents of the transformer - under normal operation the currents oppose each other, but a fault causes an imbalance that triggers the relay.

Uploaded by

HARIHARAN
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Differential Protection of

Transformer | Differential Relays


Previous
Next
Generally Differential protection is provided in the electrical
power transformer rated more than 5MVA. The Differential
Protection of Transformer has many advantages over other
schemes of protection. 1) The faults occur in the transformer inside
the insulating oil can be detected by Buchholz relay. But if any fault
occurs in the transformer but not in oil then it can not be detected
by Buchholz relay. Any flash over at the bushings are not
adequately covered by Buchholz relay. Differential relays can
detect such type of faults. Moreover Buchholz relay is provided in
transformer for detecting any internal fault in the transformer but
Differential Protection scheme detects the same in more faster way.
2) The differential relays normally response to those faults which
occur in side the differential protection zone of transformer.

Differential Protection Scheme in a Power


Transformer
Principle of Differential Protection
Principle of Differential Protection scheme is one simple
conceptual technique. The differential relay actually compares
between primary current and secondary current of power
transformer, if any unbalance found in between primary and
secondary currents the relay will actuate and inter trip both the
primary and secondary circuit breaker of the transformer.
Suppose you have one transformer which has primary rated current
Ip and secondary current Is. If you install CT of ratio Ip/1A at the
primary side and similarly, CT of ratio Is/1A at the secondary side of
the transformer. The secondaries of these both CTs are connected
together in such a manner that secondary currents of both CTs will
oppose each other. In other words, the secondaries of both CTs
should be connected to the same current coil of a differential relay
in such an opposite manner that there will be no resultant current in

that coil in a normal working condition of the transformer. But if any


major fault occurs inside the transformer due to which the normal
ratio of the transformer disturbed then the secondary current of
both transformers will not remain the same and one resultant
current will flow through the current coil of the differential relay,
which will actuate the relay and inter trip both the primary and
secondary circuit breakers. To correct phase shift of current because
of star - delta connection of transformer winding in the case of
three-phase transformer, the current transformer secondaries
should be connected in delta and star as shown here.

At maximum through fault current, the spill output produced by the


small percentage unbalance may be substantial. Therefore,
differential protection of transformer should be provided with a
proportional bias of an amount which exceeds in effect the
maximum ratio deviation.

You might also like