PHY Layer Simulation - OFDM System
PHY Layer Simulation - OFDM System
OFDM System
Team
EESC 6390
Introduction to Wireless
Communications
The OFDM block diagram with IFFT/FFT implementation from figure 12.7, from
Wireless Communications by Andrea Goldsmith is employed for simulation of
AWGN, Multipath channels. The simulations are averaged over a 1000 blocks.
1&2. The AWGN channel is simulated and the BER plot for the BPSK modulation
schemeis as shown below
3. The multipath channels are simulated for Indoor and street to street
WINNER/ITU models for channel B based on the relative power and delay
provided using BPSK modulation scheme.
4. The multipath channels are simulated for Indoor and street to street
WINNER/ITU models using QPSK and 16 QAM modulation schemes. The QPSK plot
is shown below:
16 QAM:
5. Adaptive modulation A look table for threshold SNR for different modulation
schemes of BPSK, QPSK, 8-PSK, 32-QAM and 64-QAM is created for the required
bit error rate of10 . The modulation scheme is changed when the SNR drops
before the threshold level.
The threshold SNR is calculated using the equations:
References:
[1] Wireless communications by Andrea Goldsmith.
[2] WiMAX General information about standard 802.16 Application Note by
Rhode & Schwarz.
[3] WiMAX/MobileFi: Advanced Research and Technology by Yang Xiao.
[4] Understanding OFDM Transmission www. Dspblog.com