Scribd
Upload
42 views

In Circcuit Serial Programming

This document provides recommendations for circuit layouts connected to an AVR microcontroller for in-system programming. It recommends including a 100nF capacitor and 10K resistor on the reset line, as close as possible to the reset pin. Capacitors on the programming lines should be avoided if possible, but less than 10nF is suggested if they must be included. Diagrams show the recommended reset and programming line circuits based on Atmel's guidelines.

Uploaded by

GaneshVenkatachalam
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
42 views

In Circcuit Serial Programming

This document provides recommendations for circuit layouts connected to an AVR microcontroller for in-system programming. It recommends including a 100nF capacitor and 10K resistor on the reset line, as close as possible to the reset pin. Capacitors on the programming lines should be avoided if possible, but less than 10nF is suggested if they must be included. Diagrams show the recommended reset and programming line circuits based on Atmel's guidelines.

Uploaded by

GaneshVenkatachalam
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Target Circuit Layouts

This section deals with connections to the AVR microcontroller for In System Programming. The rules and
suggestions given do not have to be followed in all circumstances but failure to include some features
may lead to problems with In System Programming.
Different programmers have more or less tolerance to deviation from these rules, but in general they
should be followed. Atmel give recommendations for circuits connected to reset pin and programming
lines that that err on the side of caution. These circuits are shown here with Kanda recommendations on
the following pages.

Atmels recommended Reset


Circuit
Note that Atmel recommend a diode
in the reset circuit. This is not
generally required for Kanda
programmers.
Atmel recommend a 10 nF capacitor
and a 4K7 resistor. We favour a
100nF capacitor and 10K resistor.
Choose something in this range.

Atmels recommended Programming


Lines Circuit
The recommended resistor values are 4K7 to isolate user applications from programming lines.

Capacitors on Reset Line


We do recommend that a capacitor is included on the Reset line. It should be placed as close as possible
to the Reset Pin on the AVR i.e. it should be closer to the Reset Pin than any resistor. We recommend a
100nF capacitor and a 10K resistor. Larger capacitors may mean that the programming speed must be
reduced. Capacitors on the programming lines should be avoided where possible, otherwise programming
speeds may have to be reduced. If you must include them, then less than 10nF is suggested.
The following diagrams of correct and incorrect circuits do not include any capacitors. As long as capacitors are placed next to the AVR pins, then they will not affect the circuit, but see previous paragraph.

web site: www.kanda.com


Phone/Fax: +44 (0)8707 446 807
email: [email protected]

web site: www.kanda.com


Phone/Fax: +44 (0)8707 446 807
email: [email protected]

You might also like