Scribd
Upload
126 views

Lecture34 PDF

This document discusses different types of linear antenna arrays with uniform element spacing but nonuniform amplitude distributions, including binomial arrays. It provides the following key points: 1) Binomial arrays have very low sidelobe levels (no sidelobes if element spacing is less than half the wavelength) but do not have good directivity and have the largest beamwidth compared to other array types. 2) The excitation amplitudes of a binomial array are determined from Pascal's triangle and follow a binomial distribution, but this results in too wide of variation in amplitudes. 3) The directivity and beamwidth of a binomial array can be estimated using closed-form expressions that depend on the number of array elements and spacing between

Uploaded by

Ankan Gayen
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
126 views

Lecture34 PDF

This document discusses different types of linear antenna arrays with uniform element spacing but nonuniform amplitude distributions, including binomial arrays. It provides the following key points: 1) Binomial arrays have very low sidelobe levels (no sidelobes if element spacing is less than half the wavelength) but do not have good directivity and have the largest beamwidth compared to other array types. 2) The excitation amplitudes of a binomial array are determined from Pascal's triangle and follow a binomial distribution, but this results in too wide of variation in amplitudes. 3) The directivity and beamwidth of a binomial array can be estimated using closed-form expressions that depend on the number of array elements and spacing between

Uploaded by

Ankan Gayen
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Lecture-6

6.3.6 N-Element Linear Array: Uniform Spacing, Nonuniform Amplitude


Uniform amplitude arrays produce small half-power beamwidth and possess the largest directivity. But in
certain instances the sidelobe level of the radiation pattern has to be maintained at a desired level. The
sidelobe level can be reduced by varying the amplitude excitations of the array elements. Nonuniform
amplitude excitations of a linear antenna array produce a pattern with smaller sidelobe level and a slightly
increased half power beamwidth in comparison to the uniform linear antenna array.
In this section, we will discuss arrays with uniform spacing but nonuniform amplitude distribution. Often,
the broadside arrays are classified according to the type of their excitation amplitude. The categories are:
(a) Uniform amplitude array: Relatively high directivity, but the side-lobe levels are high;
(b) DolphChebyscheff array: For a given number of elements, its maximum directivity is next to that of
the uniform array. Side-lobe levels are the lowest in comparison with the other two types of arrays for
a given directivity;
(c) Binomial array: Does not have good directivity but has very low side-lobe levels (when the element
spacing is equal or less than /2, there are no side lobes at all).
Array Factor Analysis for Non-uniform Array
A simplification to the array factor can be made by symmetrically placing the array elements. Consider an
array with an even number of isotropic elements (2M, where M is an integer) and suppose these are
located symmetrically about the origin of the coordinate system (defined as the z-axis in this case, which
is also the physical center of the array). The separation between the elements is d.
Y

a2

aM

a1

a1
d

d/2

d/2

aM

a2

Fig.6.16 Nonuniform amplitude array of even number of elements.


Assuming that the amplitude excitation is symmetrical about the origin, the array factor for a nonuniform
amplitude, broadside array can be written as:

( AF ) 2 M a1e
a2 e

j(

3 kd cos
)
2

j(

kd cos
)
2

a M e
M

or

a2 e

j(

j(

a M e

( 2 M 1) kd cos
)
2

( AF ) 2 M 2 a n cos[
n 1

3 kd cos
)
2

(2n 1)
kd cos ]
2

( 2 M 1) kd cos
)
2

a1e

j(

kd cos
)
2

In the normalized form, it reduces to


M

( AF ) 2 M a n cos[
n 1

(2n 1)
kd cos ]
2

(6.46)

where an' s are the excitation coefficients of the array element.


Similarly, for odd number of elements (2M+1), the array factor can be written as
M 1

( AF ) 2 M 1

n 1

cos[( n 1) kd cos ]

(6.47)

The amplitude excitation of the center element is 2a1, in this case.

6.3.7 Binomial Array:


The binomial array was investigated and proposed by J. S. Stone to synthesize patterns without side lobes.
Let us first consider a 2element array with equal current amplitudes and spacing, the array factor is given
by
AF 1 e j

(6.48)

For a broadside array ( = 0) with element spacing d less than one-half wavelength, the array factor has
no sidelobes. This can be proved in the following way:
AF

1 cos 2 sin 2 21 cos 4 cos 2


2

where = kd cos. The first null of this array factor can be obtained as:

1 2

d cos n
2
2


n cos 1

2d

As long as the d < /2, the first null does not exist. If d = /2, then null will be at = 00 and 1800. Thus, in
the visible range of , all secondary lobes are eliminated.
An array formed by taking the product of two arrays of this type gives:

AF 1 e j 1 e j 1 2e j e j 2

(6.49)

This array factor, being the square of an array factor with no sidelobes, will also has no sidelobes.
Mathematically, the array factor above represents a 3-element equally-spaced array driven by current
amplitudes with ratios of 1:2:1. In a similar fashion, equivalent arrays with more elements may be
formed.
2-element AF 1 e j

3-element AF 1 e j

1 2e j e j 2

4-element AF 1 e j

1 3e j 3e j 2 e j 3

Similarly for N-element the array factor can be expressed as

N-element AF 1 e j

N 1

(6.50)

If d /2, the above AF does not have side lobes regardless of the number of elements N. The excitation
amplitude distribution can be obtained easily by the expansion of the binome in (6.50). Making use of
Pascals triangle, this can be given by:
1
1 1
1 2 1
1 3 3 1
1
1

10

4
10

1
5 1

.............................
The relative excitation amplitudes at each element of an (N+1) element array can be determined from this
traiangle. An array with a binomial distribution of the excitation amplitudes is called a binomial array.

AF 1 e j

N 1

1 N 1e j

N 1N 2 e j
2!

N 1N 2N 3 e j 3
3!

(6.51)

The excitation distribution as given by the binomial expansion gives the relative values of the amplitudes.
It is immediately seen that there is too wide variation of the amplitude, which is a disadvantage of the
binomial arrays. The overall efficiency of such an antenna would be low. Besides, the binomial array has
a relatively wide beam. Its HPBW is the largest as compared to the uniform or the DolphChebyshev
array.
An approximate closed-form expression for the HPBW of a binomial array with d = /2 is
HPBW

1.06
N 1

1.06
2L /

1.75
L/

where L = (N-1)d is the array length.


The directivity of a broadside binomial array with spacing d = /2 can be calculated as:
D0

cos cos
2

2 N 1

(6.52)

D0

2 N 2 2 N 4 2
2 N 3 2 N 5 1

D0 1.77 N 1.77 1 2 L /

(6.52)

The array factor of a 10 element broadside binomial array (N = 10) is shown below.

(a) d = /2
Fig.6.17 Radiation pattern for 10- element broadside binomial array

(b) d = 3/4

You might also like