Welcom to use wirless usb adapter instruction book for the
driver
Notice:
1.
this instruction only be used to study and communicate.
If you want to
test it , pls use it in your AP, and do not use it in illegal mean.
2.
Pls install driver first, then insert wireless adapter.
(Notice : Before you install driver, pls do not insert wireless adapter)
1. Install the driver
Put the driver cd into CD-ROM, then open the CD file,click the 3070
driver ,then choose the the corresponding system
Double click
,then to install(Notice : Before you install driver,
pls do not insert wireless adapter)
Choose
, then clickNext
Choose the automatic icon
,then click Next
Appearing the following picture,then choose the icon
clich Next
and
After seeing the following pictures ,then click install,Notice:If the
driver couldnot be setup,pls close your antivirus program before
installing,because some antivirus maybe influenced the the installation
The driver is installing ,picture as follows
After installed the driver ,then click Finish
You will see an icon
in your taskbar of computer after installed the driver,it
means the driver installation be finished.Then insert our wireless usb adapter to
you computer ,after finished the automatic updates ,the computer can connect
network which donot need any password
2.Preferences of Network
Double click the icon
which in the lower right of Taskbar,appearing the
following picture
Clink the buttom
,refresh the network (The more you refresh ,the more networks you
buttom
will see
appearing the following picture,then click the the
Click and choose the
network (SSID ,which you should know the
password .here ,for example ,TYY ) .Then click the buttom
picture ,appearing the following picture:
which in above
Then click the icon
Click the icon
(Next),appearing the picture as follows
again,you will see the pictrue
Enter the password in the blank area of WEP Key,then click the icon
,appearing the following picture:
(Notice :you should enter the correct password ,or else you wouldnt connect
the network and get the IP )
If
there
are
several
networks
,you
can
click
the
Use
Pre-logon
Connection ,in this case ,you can pre-connect this network.
Click the icon
Click the network TYY then click the icon
The softeware can get the IP address automatically ,after connect it
successfully ,then you can share the internet .