Scribd
Upload
29 views

Regenerative Circuits+++

Circuit 1 returns oil flow from a cylinder's head end to its cap end to achieve rapid rod extension with no load. Circuit 2 combines rapid extension with full force when a load is encountered by opening a sequence valve to allow oil from the head end to flow to tank. Circuit 3 provides full force like Circuit 2 but uses an orifice and check instead of a sequence valve, resulting in some backpressure. Circuit 4 uses a limit switch to activate and deactivate a regenerative circuit, extending the cylinder with solenoids before discharging fluid to tank upon switch activation.

Uploaded by

Emad Elsaid
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
29 views

Regenerative Circuits+++

Circuit 1 returns oil flow from a cylinder's head end to its cap end to achieve rapid rod extension with no load. Circuit 2 combines rapid extension with full force when a load is encountered by opening a sequence valve to allow oil from the head end to flow to tank. Circuit 3 provides full force like Circuit 2 but uses an orifice and check instead of a sequence valve, resulting in some backpressure. Circuit 4 uses a limit switch to activate and deactivate a regenerative circuit, extending the cylinder with solenoids before discharging fluid to tank upon switch activation.

Uploaded by

Emad Elsaid
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

print | close

Regenerative circuits
(Unpublished) Hydraulics & Pneumatics
Sun, 2012-01-01 (All day)

Circuit 1

Circuit 1
Rapid rod extension can be achieved by returning the flow of oil from a cylinder's head end back into its cap
end. With no load, pressure in both head and cap ends is equal, so when the load is encountered, available
working force depends on the differential area.

Circuit 2
Combining the rapid extension of Circuit 1 with full force in
response to an applied load takes full advantage of a
regenerative circuit. This circuit produces a rapid approach
stroke of the piston. When the rod encounters resistance
(workpiece load), pressure rises on the cap end to open the
sequence valve and allow oil from the head end to flow to
tank through the 4-way valve. Once this occurs, full effective
force on the workpiece becomes available.

Circuit 3
This circuit provides a costly means to accomplish the same
end as Circuit 2. Instead of a sequence and built-in check, an
orifice and check are used. There is some backpressure
remaining in the cylinder's head end because of the orifice
resistance during final squeeze. But with the cylinder
extended, no fluid flows across the orifice, so total available
force acts on the cap end. Whether or not this circuit is appropriate for a given application depends on working
force requirements.

Circuit 4
When electrical control is desired, a limit or proximity switch can be used to activate and de-activate a
regenerative circuit. In the circuit shown, energizing solenoids a and b extends the cylinder in a differential
circuit. The limit switch de-energizes solenoid b, directing cylinder discharge fluid to tank.

Source URL:
http://hydraulicspneumatics.com/200/TechZone/HydraulicValves/Article/False/6475/TechZoneHydraulicValves

You might also like