Scribd
Upload
229 views

Culvert Location

Culvert location is an important design consideration. Culverts should be placed on existing stream alignments with direct inlet and outlet paths to efficiently convey drainage water across roadways. Factors like economics, environmental permitting, hydraulics, and maintenance should guide culvert alignment choices. Sediment deposition in culverts is influenced by the relative sediment transport capacities of flow in streams versus culverts. Culvert placement in both plan and profile views impacts sediment accumulation, such as avoiding locations inside stream bends where point bars commonly form.

Uploaded by

Qaiser Khan
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
229 views

Culvert Location

Culvert location is an important design consideration. Culverts should be placed on existing stream alignments with direct inlet and outlet paths to efficiently convey drainage water across roadways. Factors like economics, environmental permitting, hydraulics, and maintenance should guide culvert alignment choices. Sediment deposition in culverts is influenced by the relative sediment transport capacities of flow in streams versus culverts. Culvert placement in both plan and profile views impacts sediment accumulation, such as avoiding locations inside stream bends where point bars commonly form.

Uploaded by

Qaiser Khan
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

CULVERTS

DRAINAGE CRITERIA MANUAL (V. 2)

7.0 GENERAL CONSIDERATIONS


7.1 Culvert Location
Culvert location is an integral part of the total design. The main purpose of a culvert is to convey
drainage water across the roadway section expeditiously and effectively. The designer should identify all
live stream crossings, springs, low areas, gullies, and impoundment areas created by the new roadway
embankment for possible culvert locations. Note that environmental permitting constraints will often apply
for new culverts or retrofits, such as a Section 404 permit that regulates construction activities in
jurisdictional wetlands and Waters of the United States.
Culverts should be located on existing stream alignments and aligned to give the stream a direct entrance
and a direct exit. Abrupt changes in direction at either end may retard the flow and make a larger
structure necessary. If necessary, a direct inlet and outlet may be obtained by means of a channel
change, skewing the culvert, or a combination of these. The choice of alignment should be based on
economics, environmental concerns, hydraulic performance, and/or maintenance considerations.
If possible, a culvert should have the same alignment as its channel. Often this is not practical and where
the water must be turned into the culvert, headwalls, wingwalls, and aprons with configurations similar to
those in Figure CU-13 should be used as protection against scour and to provide an efficient inlet.
7.2 Sedimentation
Deposits usually occur within the culvert barrels at flow rates smaller than the design flow. The deposits
may be removed during larger floods dependent upon the relative transport capacity of flow in the stream
and in the culvert, compaction and composition of the deposits, flow duration, ponding depth above the
culvert, and other factors.
Culvert location in both plan and profile is of particular importance to the maintenance of sediment-free
culvert barrels. Deposits occur in culverts because the sediment transport capacity of flow within the
culvert is often less than in the stream.
Deposits in culverts may also occur due to the following conditions:

At moderate flow rates the culvert cross section is larger than that of the stream, so the flow
depth and sediment transport capacity is reduced.

Point bars form on the inside of stream bends. Culvert inlets placed at bends in the stream will
be subject to deposition in the same manner. This effect is most pronounced in multiple-barrel
culverts with the barrel on the inside of the curve often becoming almost totally plugged with
sediment deposits.

CU-32

07/2001
Urban Drainage and Flood Control District

You might also like