Scribd
Upload
248 views11 pages

Development of Bearing Capacity Theory Terzaghi's Bearing Capacity Theory

Terzaghi and Meyerhof developed early theories of bearing capacity for shallow foundations. Terzaghi assumed the soil below the foundation had no shear strength and the failure surface consisted of three zones. Meyerhof modified this by assuming the failure surface extended to the ground surface. Both theories provide equations for calculating bearing capacity based on soil properties and shape/depth factors. Later researchers improved on these theories by relaxing assumptions and incorporating additional soil parameters.

Uploaded by

kecomir
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
248 views11 pages

Development of Bearing Capacity Theory Terzaghi's Bearing Capacity Theory

Terzaghi and Meyerhof developed early theories of bearing capacity for shallow foundations. Terzaghi assumed the soil below the foundation had no shear strength and the failure surface consisted of three zones. Meyerhof modified this by assuming the failure surface extended to the ground surface. Both theories provide equations for calculating bearing capacity based on soil properties and shape/depth factors. Later researchers improved on these theories by relaxing assumptions and incorporating additional soil parameters.

Uploaded by

kecomir
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 11

Module 2 : Theory of Earth Pressure and Bearing Capacity

Lecture 8 : Development of Bearing Capacity Theory [ Section 8.1: Terzaghi's & Meyerhof's Bearing
Capacity Theory ]

Objectives
In this section you will learn the following
Development of Bearing Capacity Theory
Terzaghi's Bearing Capacity Theory
Assumptions in Terzaghis Bearing Capacity Theory.
Meyerhof's Bearing Capacity Theory

Bearing capacity of square and circular footings

>

Module 2 : Theory of Earth Pressure and Bearing Capacity


Lecture 8 : Development of Bearing Capacity Theory [ Section 8.1: Terzaghi's & Meyerhof's Bearing
Capacity Theory ]
8.1 Development of Bearing Capacity Theory
Application of limit equilibrium methods was first done by Prandtl on the punching of thick masses of metal.
Prandtl's methods was adapted by Terzaghi to bearing capacity failure of shallow foundations. Vesic and
others improved on Terzaghi's original theory and added other factors for a more complete analysis.
1. Terzaghis Bearing Capacity Theory:
Assumptions in Terzaghis Bearing Capacity Theory.
Depth of foundation is less than or equal to its width.
Base of the footing is rough.
Soil above bottom of foundation has no shear strength; it is only a surcharge load against the overturning
load
Surcharge upto the base of footing is considered.
Load applied is vertical and non-eccentric.
The soil is homogenous and isotropic.
L/B ratio is infinite.

Fig. 2.25 Terzaghis Bearing Capacity Theory

Module 2 : Theory of Earth Pressure and Bearing Capacity


Lecture 8 : Development of Bearing Capacity Theory [ Section 8.1: Terzaghi's & Meyerhof's Bearing
Capacity Theory ]
Consider a footing of width B and depth D f loaded with Q and resting on a soil of unit weight . The failure
of the zones is divided into three zones as shown below. The zone1 represents an active Rankine zone, and
the zones 3 are passive zones. The boundaries of the active Rankine zone rise at an angle of
, and
with the horizontal. The zones 2 are known as zones of radial shear,
those of the passive zones at
because the lines that constitute one set in the shear pattern in these zones radiate from the outer edge of
the base of the footing. Since the base of the footing is rough, the soil located between it and the two
surfaces of sliding remains in a state of equilibrium and acts as if it formed part of the footing. The surfaces
to the horizontal. At the instant of failure, the pressure on each of the surfaces ad and bd
ad and bd rise at
is equal to the resultant of the passive earth pressure

and the cohesion force

. Since slip occurs along

to the normal on each face and as a consequence in


these faces, the resultant earth pressure acts at angle
a vertical direction. If the weight of the soil adb is disregarded, the equilibrium of the footing requires that
---------- (1)
The passive pressure required to produce a slip on def can be divided into two parts,
represents the resistance due to weight of the mass adef. The point of application of
lower third point of ad. The force

and

. The force

is located at the

acts at the midpoint of contact surface ad.

The value of the bearing capacity may be calculated as :


----------(2 )
by introducing into eqn(2) the symbols,

Module 2 : Theory of Earth Pressure and Bearing Capacity


Lecture 8 : Development of Bearing Capacity Theory [ Section 8.1: Terzaghi's & Meyerhof's Bearing
Capacity Theory ]

we obtain,
the quantities

---------- (3 )
are called bearing capacity factors.

where K p= passive earth pressure coefficient

Fig. 2.26 Variation of bearing capacity factors


with soil friction angle.

Module 2 : Theory of Earth Pressure and Bearing Capacity


Lecture 8 : Development of Bearing Capacity Theory [ Section 8.1: Terzaghi's & Meyerhof's Bearing
Capacity Theory ]
The use of chart figure (2.27) facilitates the computation of the bearing capacity. The results obtained by this
chart are approximate.
Loaded strip, width B, Total load per unit length of footing
General shear failure :
Local shear failure :
Square footing, width B
Total critical load : :

Fig. 2.27 Chart Showing Relation between Angle of Internal Friction and Bearing Capacity Factors.

Module 2 : Theory of Earth Pressure and Bearing Capacity


Lecture 8 : Development of Bearing Capacity Theory [ Section 8.1: Terzaghi's & Meyerhof's Bearing
Capacity Theory ]
Table 2.5 : Terzaghis bearing capacity factors

0
5
10
15
20
25
30
34
2.

5.7
7.3
9.6
12.9
17.7
25.1
37.2
52.6

1.0
1.6
2.7
4.4
7.4
12.7
22.5
36.5

0.0
0.5
1.2
2.5
5.0
9.7
19.7
30.0

35
40
45
48
50
-

57.8
95.7
172.3
258.3
347.5
-

41.4
81.3
173.3
287.9
415.1
-

42.4
100.4
297.5
780.1
1153.2
-

Meyerhofs Bearing Capacity Theory


The form of equation used by Meyerhof (1951) for determining ultimate bearing capacity of symmetrically
loaded strip footings is the same as that of Terzaghi but his approach to solve the problem is different. He
assumed that the logarithmic failure surface ends at the ground surface, and as such took into account the
resistance offered by the soil and surface of the footing above the base level of the foundation. The different
zones considered are shown in fig. 2.28

Fig. 2.28 Failure zones considered by Meyerhof

Module 2 : Theory of Earth Pressure and Bearing Capacity


Lecture 8 : Development of Bearing Capacity Theory [ Section 8.1: Terzaghi's & Meyerhof's Bearing
Capacity Theory ]
In this, EF failure surface is considered to be inclined at an angle of

with the horizontal followed by

FG which is logspiral curve and then the failure surface extends to the ground surface (GH).
EF is considered as a imaginary retaining wall face with failure surface as FGH. This problem is same as the
retaining wall with the inclined backfill at an angle of a. For this case the passive earth pressure acting on the
is given by Caqnot and Kerisel (1856). Considering the equilibrium of the failure zone,
retaining wall

where,
is the load on the footing,
W is the weight of the active zone and,
is the vertical component of the passive pressure acting on walls JF and EF.
Then the ultimate bearing capacity

Where,
B is the width of the footing.
Comparing the above equation with,

We get ,

is given as,

Module 2 : Theory of Earth Pressure and Bearing Capacity


Lecture 8 : Development of Bearing Capacity Theory [ Section 8.1 Terzaghi's Bearing Capacity
Theory ]
The form of equation proposed by Meyerhof (1963) is,

where,
= Bearing capacity factors for strip foundation,
c = unit cohesion,
= Shape factors,
= inclination factors for the load inclined at an angle a 0 to the vertical,
= Depth factors,
= effective unit weight of soil above base level of foundation,
= effective unit weight of soil below foundation base,
D = depth of the foundation.

Module 2 : Theory of Earth Pressure and Bearing Capacity


Lecture 8 : Development of Bearing Capacity Theory [ Section 8.1: Terzaghi's & Meyerhof's Bearing
Capacity Theory ]
Table 2.6 : Shape, depth and inclination factors for Meyerhof bearing capacity
Factors

Value

For
Any

Shape

> 10
=0
Any

Depth

> 10
=0
Any

Inclination

> 10
=0
In the above table,
= angle of resultant measured from vertical without sign,
B = width of footing,
L = length of footing,
D = depth of footing.

Module 2 : Theory of Earth Pressure and Bearing Capacity


Lecture 8 : Development of Bearing Capacity Theory [ Section 8.1: Terzaghi's & Meyerhof's Bearing
Capacity Theory ]
3.

Bearing capacity of square and circular footings


If the soil support of a continuous footing yields due to the imposed loads on the footings, all the soil particles
move parallel to the plane which is perpendicular to the centre line of the footing. Therefore the problem of
computing the bearing capacity of such footing is a plane strain deformation problem. On the other hand if
the soil support of the square and circular footing yields, the soil particles move in radial and not in parallel
planes. Terzaghi has proposed certain shape factors to take care of the effect of the shape on the bearing
capacity. The equation can be written as,

where,
are the shape factors whose values for the square and circular footings are as follows,
For long footings:
For square footings:
For circular footings:
For rectangular footing of length L and width B :

Skempton has given the values of N c for purely cohesive soils, as given below:
For ( D f / B) < 2.5,
( Nc ) for rectangular footing =

( Nc ) for circular and rectangular footing =


For ( D f / B) >= 2.5,
( Nc ) for rectangular footing =
Then,

Where,
C u is the undrained cohesion of the soil.

Module 2 : Theory of Earth Pressure and Bearing Capacity


Lecture 8 : Development of Bearing Capacity Theory [ Section 8.1: Terzaghi's & Meyerhof's Bearing
Capacity Theory ]

Recap
In this section you have learnt the following
Development of Bearing Capacity Theory
Terzaghi's Bearing Capacity Theory
Assumptions in Terzaghis Bearing Capacity Theory.
Meyerhof's Bearing Capacity Theory
Bearing capacity of square and circular footings
Congratulations, you have finished Lecture 8. To view the next lecture select it from the left hand
side menu of the page

You might also like