YOUR CARBS ARE

NAKED
2




Table of Contents


Hitachi Page 3
o Pilot fuel Page 4
o Main fuel Page 8
Mikuni Page 11
o Pilot fuel Page 13
o Main fuel Page 21
o Starter/enrichment Page 25



For clarity, all passages with air flowing through them are highlighted in light
blue. Fuel flow through a circuit is shown in red. Where air and fuel have
mixed, the color changes to purple.

Since both the Mikuni and Hitachi carbs used on the XJ -series bikes are similar in
function and design, you may want to read through the whole document to get a
better idea of whats going on. For example, as you can see above, there is no
starter/enrichment section for the Hitachi carbs, but the pictures in the Mikuni
section should help you get the idea.
3
HITACHI INSIDE








Ever wanted to see just exactly whats on the inside of your carbs? Heres your chance. We took a
carb body that was beyond repair and sliced it open to reveal whats hidden inside. Lets take a look
at this Hitachi HSC-33 from a California model 700 Maxim. This model is almost identical to the
HSC-32 model used on most of the 650cc and 750cc aircooled engines.



4



Oh, so thats how they put those passages in there they drill them straight in. Where they dont
need the passage to go, they block it off with a brass plug. Nifty!


5


Those brass plugs, however, can pose a problem. They create a spot in the passage where dirt
and/or varnish can accumulate, and can partially or even completely block off the passage.
6

Here we see the path the air and fuel take through the circuit. Helpfully color-coded, of course. Red
dashed line shows the normal fuel level.

7


Heres a closeup of where the fuel from the pilot jet mixes with the air stream. See how tiny that hole
is? That right there demonstrates why you need to keep your jets and passages zestfully clean.

8


Heres the other side of the equation the main fuel circuit.


9


Again, we dont have the air or fuel jets visible, nor the emulsion tube. As before, theres a brass plug
this time sealing the hole drilled to link the air jet passage to the emulsion tube cavity.
10


We cant let you forget how high the fuel sits, can we? That or we just really like dashed red lines.


11
MIKUNI INSIDE



Now we look at the other brand of carb in use on our bikes Mikuni. This BS28 model came off a
550 Seca. You can see the cut lines above.
12

Another hapless carb body with a broken float pillar sacrificed in the name of knowledge. The
observant reader will note the pilot circuit and choke/enrichment circuits on the left, as well as the
exposed mixture screw area. The right section contains the main fuel circuit.

13


Here we see the Mikuni pilot fuel circuit in all its naked glory. Very similar to the Hitachi in how its laid
out.

14

In the picture above, the blue arrow shows where the pilot air jet would sit. The red arrow points to
where the pilot fuel jet goes. The yellow arrows point out the ever-present brass sealing plugs.
15

(Helpful picture of what a pilot air jet might look like.)

16



Other Mikuni models, like this BS33 from a Maxim-X, move the pilot air jet from under the diaphragm
to a passage located in the left side of the carb throat.


17


Air enters on the left, travels down and across. The vacuum created by the air movement draws up
fuel through the pilot fuel jet, where it mixes with the air. The air/fuel mixture then travels up, and the
purple arrow shows where it feeds into the passage going to the pilot/idle mixture screw and bypass
holes (shown on the next page). Red horizontal dashed/dotted line indicates where the fuel level in
the bowl should normally be.

18

Heres the other end of the pilot circuit. Up top you can see where the threaded hole where pilot/idle
mixture screw sits. The horizontal passage has the requisite sealing plug.
19

A closeup of the pilot circuit feed holes.

The hole nearest the brass plug is where the tip of the pilot mixture screw goes (shown on the next
page). It sits on the engine side of the butterfly valve and supplies fuel from the pilot circuit even
when the throttle is closed.

The other feed holes (there are anywhere between two and four of them, depending on make and
model) sit on or behind the butterfly when it is closed. Because of this, they dont really provide much
in the way of fuel at idle; however, when one twists the throttle and opens the butterfly, these holes
are exposed to engine vacuum. This pulls in more fuel mixture from the pilot circuit, and causes your
four cylinders of metric mechanical goodness to roar to life. This is the equivalent of a subsystem on
other carburetor models known as an accelerator pump.

The purple arrows indicate direction of travel for the air/fuel mixture coming from the pilot fuel circuit.


20
















































Here with the mixture screw in place.


21

The airbox side of the carb body, with the main air jet on the right, neatly sliced in half.
22



Main air jet, from the side. Teensy little hole, aint it? Good thing its an air jet, so its unlikely to get
clogged up by gas varnish.
23

After making its way through the main jet, the air comes down that sloping passage, swirls around the
emulsion tube and enters through those tiny holes.

24

The fuel is drawn up through the main jet at the bottom (which holds the emulsion tube in place) and
mixes with the air. The mixture exits the top of the emulsion tube and feeds your hungry, hungry
engine.
25

Now lets take a peek at the enrichment fuel circuit. Were looking at the Mikuni here, but it works the
same way on the Hitachis as well.

You know that dinky little fuel jet that sits waaaaaaaay down in the bowl thats a bear to open up if it
ever gets clogged? Heres where the fuel goes after it gets sucked up through that jet.
26


Red arrow: Where the fuel gets drawn into the enrichment tube.

Blue arrow: Air enters the tube and mixes with the fuel.

Purple arrow: The passage leading to the starter plunger.
27



Now colorized for your viewing pleasure.
28



Heres the other end of the circuit.

Red arrow: Home of the starter plunger.

White arrow: exit point for the enrichment circuit, just past the butterfly. Air/fuel comes out here when
the starter plunger is opened.

Blue arrow (hey, were being patriotic here!): where the pilot mixture screw lives. (That was back on
pages 18-20.)
29

Thats the bottom of the enrichment tube. If thats not an advertisement for keeping your passages
and jets open and zestfully clean, I dont know what is.


And with that, we end our x-ray tour of your carbs. Go forth, be fruitful, and colortune.









Many thanks to xjbikes.com user Rice_Burnarr for his superlative work in dissecting the donor carbs
used here.

Copyright 2012 xj4ever.com and Schmuckatelli Heavy Industries
[email protected]