Scribd
Upload
1K views

LCD Connection With Arduino (ATmega328p) On ISIS Proteus

This document demonstrates using a LiquidCrystal library with a 16x2 LCD display to print "Hello World!" and the current time in seconds. It describes the circuit connections between the LCD and Arduino and credits the origins and modifications of the library over time.

Uploaded by

Enrique Quintana
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
1K views

LCD Connection With Arduino (ATmega328p) On ISIS Proteus

This document demonstrates using a LiquidCrystal library with a 16x2 LCD display to print "Hello World!" and the current time in seconds. It describes the circuit connections between the LCD and Arduino and credits the origins and modifications of the library over time.

Uploaded by

Enrique Quintana
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

/*

LiquidCrystal Library - Hello World



Demonstrates the use a 16x2 LCD display. The LiquidCrystal
library works with all LCD displays that are compatible with
the
Hitachi HD44780 driver. There are many of them out there, and
you
can usually tell them by the 16-pin interface.

This sketch prints "Hello World!" to the LCD
and shows the time.

The circuit:
* LCD RS pin to digital pin 12
* LCD Enable pin to digital pin 11
* LCD D4 pin to digital pin 5
* LCD D5 pin to digital pin 4
* LCD D6 pin to digital pin 3
* LCD D7 pin to digital pin 2
* LCD R/W pin to ground
* 10K resistor:
* ends to +5V and ground
* wiper to LCD VO pin (pin 3)

Library originally added 18 Apr 2008
by David A. Mellis
library modified 5 Jul 2009
by Limor Fried (http://www.ladyada.net)
example added 9 Jul 2009
by Tom Igoe
modified 22 Nov 2010
by Tom Igoe

This example code is in the public domain.

http://www.arduino.cc/en/Tutorial/LiquidCrystal
*/

// include the library code:
#include <LiquidCrystal.h>

// initialize the library with the numbers of the interface pins
LiquidCrystal lcd(12, 11, 5, 4, 3, 2);

void setup() {
// set up the LCD's number of columns and rows:
lcd.begin(16, 2);
// Print a message to the LCD.
lcd.print("hello, world!");
}

void loop() {
// set the cursor to column 0, line 1
// (note: line 1 is the second row, since counting begins with
0):
lcd.setCursor(0, 1);
// print the number of seconds since reset:
lcd.print(millis()/1000);
}

You might also like