Plasma Physics and Nuclear Fusion

Outline
I

Fission versus Fusion Requirements for Fusion Plasma Characteristics Plasma Confinement Experimental Devices

Calculation of energy released

The released energy follows from the mass deficit. Consider the reaction

The masses of the different products are

The mass deficit (Total mass before minus total mass after) is

Calculation of the released energy

The mass deficit is The energy then follows from Einsteins formula

Used unit of energy is the electron volt (eV), kilo-electron volt (1keV = 1000 eV) or Mega-electron volt (1 MeV = 106 eV)

Energies in the MeV range are far in excess of usual chemical reactions
I

1 kg of a Deuterium/Tritium mixture would allow for a number of fusion reactions N

This amount of reactions would generate an energy

This is around 4 GW for 24 hours

eV is also used as the unit of Temperature

Temperature is always used to express an averaged energy. The unit is again eV, i.e.

Where T is the temperature and Tk is the temperature in Kelvin. Note

1eV = 11605 K

Distribution of energy over the products

The energy is released in the form of kinetic energy The kinetic energy is not equally distributed over the products since both energy as well as momentum need to be conserved

These equations can be solved to give

Distribution of energy
I

Momentum and energy conservation yield

Take the now famous reaction

The Helium nuclei is roughly 4 times more heavy than the neutron and will thus acquire 20% of the energy (3.5 MeV) whereas the neutron obtains 80% (14.1 MeV)

Advantages of Fusion
I

Inexhaustible Supply of Fuel

Relatively Safe and Clean

Possibility of Direct Conversion

Fusion Reactor
Two main requirements: (1) To heat the fuel to the ignition temperature (2) To confine it while it burns

Current fusion reactor concepts

are designed to operate at around 10 keV (note this is still 100 million Kelvin, matter is fully ionized or in the plasma state) Are based on a mixture Averaged reaction rates for of Deuterium and Tritium various fusion reactions as Both are related to the a function of the cross section temperature (in keV)

Fusion Power Plant

Application of fusion power

Availability of the fuel

The natural abundance of Deuterium is one in 6700. There is enough water in the ocean to provide energy for 3 1011 years at the current rate of energy consumption (larger than the age of the universe) Deuterium is also very cheaply obtainable. Calculating the price of electricity solely on the basis of the cost of Deuterium, would lead to a drop of 103 in your electricity bill Tritium is unstable with a half age of 12.3 years. There is virtually no naturally resource of Tritium

Availability of the fuel

Tritium however can be bred from Lithium

Note that the neutron released in the fusion reaction can be used for this purpose The availability of Lithium on land is sufficient for at least 1000 if not 30000 years, and the cost per kWh would be even smaller than that of Deuterium. If the oceans is included it is estimated that there is enough fuel for 3 107 years.

Why fusion .
I I I

There is a large amount of fuel available, at a very low price. Fusion is CO2 neutral. It would yield only a small quantity of high level radio active waste. There is no risk of uncontrolled energy release. The fuel is available in all locations of the earth. Fusion is of interest especially for those regions that do not have access to other natural resources. There is only a small threat to nonproliferation of weapon material

But
I

A working concept is yet to be demonstrated. The operation of a fusion reactor is hindered by several, in itself rather interesting, physics phenomena The cost argument isnt all that clear, since the cost of the energy will be largely determined by the cost of the reactor.

Limitations due to the high temperature

10 keV is still 100 million Kelvin (matter is fully ionized, i.e. in the plasma state) Some time scales can be estimated using the thermal velocity

This is 106 m/s for Deuterium and 6 107 m/s for the electrons In a reactor of 10 m size the particles would be lost in 10 s.

Two approaches to fusion

One is based on the rapid compression, and heating of a solid fuel pellet through the use of laser or particle beams. In this approach one tries to obtain a sufficient amount of fusion reactions before the material flies apart, hence the name, inertial confinement fusion (ICF).

Magnetic confinement ..
I

The Lorentz force connected with a magnetic field makes that the charged particles can not move over large distances across the magnetic field They gyrate around the field lines with a typical radius

At 10 keV and 5 Tesla this radius of 4 mm for Deuterium and 0.07 mm for the electrons

Requirements for Fusion

High Temperatures Adequate Densities Adequate Confinement Lawson Criterion: n > 1020 s/m3

Two Approaches
I

Inertial Confinement:
n 1030 / m3 N 10-10 s
N

Magnetic Confinement:
n 1020 / m3 N1s
N

Magnetic Confinement
I I I I I I I I

Magnetic Field Limit: B < 5 T Pressure Balance: nkT 0.1B2/20 ==> n 1020 / m3 @ T = 108 K Atmospheric density is 2 x 1025 / m3 Good vacuum is required Pressure: nkT 1 atmosphere Confinement: 1 s A 10 keV electron travels 30,000 miles in 1 s