Scribd
Upload
241 views2 pages

Transmission Lines and Wave Guides

The document is an exam question paper for an Electronics and Communication Engineering course. It contains 15 multiple choice and numerical problems across two sections. Section A contains 10 short answer questions worth 2 marks each. Section B contains 5 long answer questions worth 16 marks each, focusing on transmission lines, waveguides, filters and matching networks. Students are required to answer all questions in the paper covering topics such as propagation constant, crystal filters, impedance matching, transmission modes and waveguide resonators.

Uploaded by

मेनसन लाखेमरू
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
241 views2 pages

Transmission Lines and Wave Guides

The document is an exam question paper for an Electronics and Communication Engineering course. It contains 15 multiple choice and numerical problems across two sections. Section A contains 10 short answer questions worth 2 marks each. Section B contains 5 long answer questions worth 16 marks each, focusing on transmission lines, waveguides, filters and matching networks. Students are required to answer all questions in the paper covering topics such as propagation constant, crystal filters, impedance matching, transmission modes and waveguide resonators.

Uploaded by

मेनसन लाखेमरू
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

www.vidyarthiplus.

com

Reg.No. : Question Paper Code : 11335 B.E./B.Tech. DEGREE EXAMINATION , NOVEMBER/DECEMBER 2012 Fifth Semester Electronics and Communication Engineering EC 2305/EC 55 TRANSMISSION LINES AND WAVEGUIDES (Regulation 2008) Time : Three hours Answer ALL questions PART A (10 X 2 = 20 marks) 1. Define propagation constant. 2. State the significance of crystal filters in communication system. 3. A 50 coaxial cable feeds a 75 + j20 dipole antenna. Find reflection coefficient and standing wave ratio. 4. At a frequency of 80 MHz , a lossless transmission line has a characteristic impedance of 300 and a wavelength of 2.5 m. Find L and C. 5. Write the expression for VSWR in terms of (a) the reflection coefficient (b) VSWR in terms of zL and z0 . 6. Mention the significance of /4 line. 7. Compare TE and TM mode. 8. What is the need for attenuator? 9. What is the dominant TE and TM mode in rectangular waveguide? 10. How to design an air filled cubical cavity to have its dominant resonant frequency at 3 GHz? PART B (5 X 16 = 80 marks) 11. (a) (i) Explain the properties and characteristics impedance of symmetrical networks. (6) (ii) Design T and section low pass filter which has series inductance 80 mHz and shunt capacitance 0.022 f . Find the cutoff frequency and design impedance. (10) Or (b) What are the advantages of m derived filter? Design an m derived low pass filter (T and section) having design resistance R0 = 500 , cutoff frequency fc = 1500 Hz and infinite attenuation frequency f. (16) Maximum : 100 marks

www.vidyarthiplus.com

www.vidyarthiplus.com

12. (a) Explain the condition for distortionless line. Characteristic impedance of a transmission line at 8 MHz is (40-2j) ohm and the propagation constant is (0.01 + j 0.18) per meter. Find the primary constants. (16) Or (b) Discuss following : (i) Reflection on a line not terminated in Z0. (ii) Open and short circuited lines.

(8) (8)

13. (a) A 30 m long lossless transmission line with Z0 = 50 operating at 2 MHz is terminated with a load ZL = 60 + 40j . If U = 0.6C on the line, find (i) Reflection coefficient (5) (ii) Standing wave ratio (5) (iii) Input impedance (6) Or (b) Discuss the following : (i) Impedance matching (ii) Single and double stub matching.

(8) (8)

14. (a) Explain the concept of transmission of TM waves and TEM waves Between parallel plates. Or

(16)

(b) (i) Derive the relation among phase velocity , group velocity and frequency velocity. (8) (ii) Design a T and type attenuators to give attenuation of 20 dB and to Work in a line of 600 . 15. (a) Derive the field expression for TM wave propagation in rectangular waveguide stating the necessary assumptions. (16) Or (b) (i) Explain the concept of excitation of waveguides. (ii) Discuss the structure , advantage and disadvantage of resonant cavities. (8) (8)

------------------------------------------

www.vidyarthiplus.com

You might also like