Scribd
Upload
1K views

Machine Drawing Series 2 Question Paper

The document is a mechanical engineering drawing exam from St. Thomas Institute for Science and Technology in Thiruvananthapuram, India. It contains two parts - Part A focuses on machine drawing, asking students to sketch views of joints, nuts, keys, and a plummer block. Part B is to be answered separately and contains additional questions. The exam tests third semester students on their knowledge of engineering drawing concepts over 3 hours.

Uploaded by

Kailas Sree Chandran
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views

Machine Drawing Series 2 Question Paper

The document is a mechanical engineering drawing exam from St. Thomas Institute for Science and Technology in Thiruvananthapuram, India. It contains two parts - Part A focuses on machine drawing, asking students to sketch views of joints, nuts, keys, and a plummer block. Part B is to be answered separately and contains additional questions. The exam tests third semester students on their knowledge of engineering drawing concepts over 3 hours.

Uploaded by

Kailas Sree Chandran
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ST.

THOMAS INSTITUTE FOR SCIENCE AND TECHNOLOGY


THIRUVANANTHAPURAM
Class No: .. Name : .. CONTINUOUS ASSESSMENT EXAMINATION II, OCTOBER 2012 THIRD SEMESTER MECHANICAL 08.306 ENGINEERING DRAWING (Part A and Part B are to be answered in separate answer books) Time: 3 hours PART A MACHINE DRAWING Max. Marks: 50
PART I (Answer any TWO questions)

(2 x 10 marks= 20 marks)

1. Sketch two views of a single riveted double cover butt joint. Take plate thickness t = 10mm. 2. Sketch a Socket and spigot pipe joint for pipe 150mm. 3. Sketch the following Rivet heads, t = 11mm. a. Snap head b. Pan head c. Counter sunk head 4. Sketch two views of Castle nut, D = 12mm. 5. Sketch the following Keys. a. Sunk Taper key b. Hollow Saddle key c. Key with Gib-head d. Woodruff key
PART II

(30 marks)

6. Draw the following views of the Plummer Block shown in the next page. a. Right half sectional elevation. b. End view from Left

Page 1 of 4

You might also like