92-2266-01 Rev.
USB Interface Option
Contents of the USB Interface Kit
This kit contains the following items: USB Interface Card Rear Cover Plate M4 x 12 Screws (4) Datamax-ONeil Accessories CD
Tools Required
For installation, this option requires a #2 Philips screwdriver.
The USB Interface is designed to protect sensitive components from damage due to electrostatic discharge during normal operation. When installing the card, however, take CAUTION proper static-control precautions to prevent damage.
Preparing the Printer
Turn the power switch Off and unplug the AC power cord from the printer.
Remove the Cover Plate from the Card Cage at the rear of the printer by removing the two Screws.
Installing the USB Interface Card
Slide the USB Interface Card into the card cage until it fully seates into the backplane connector and secure using two Screws.
USB Interface Card
Screws
Position the Cover Plate over the card cage, as shown, and secure using two Screws.
Cover Plate
Screws
Setup and Configuration
To use the USB Interface, the printer requires an Application Version (firmware) of 7.03 or greater. Verify the current Application Version by printing a Configuration Label (see sample). If needed, update the Application Version by downloading the necessary file from ftp.datamaxoneil.com. Follow the procedure in the Operators or Maintenance Manual for the printer.
Note: The USB Interface is supported under Windows 95/98/2000/ME/XP and is not supported by
Windows NT. The examples below are from Windows 98; some of the following screens may differ or not appear on other versions of Windows.
1. Obtain the Printer Driver Pack (R13 or greater) from the Accessories CD (version 6.0 or greater) or download it from our FTP site at ftp.datamax-oneil.com.
2. After the file download has completed, run the file by double clicking it. The screen to the right will appear:
3. Click on the Unzip button. It is recommended that you do not alter the default Unzip To Folder: location. 4. Connect a USB cable (not supplied) between the PC and the printer.
USB Interface Card Connector USB Cable
WARNING
The USB Port is a device-end only connection. Never connect a keyboard, mouse, modem, etc. into this port. Damage can result.
5. Plug in the AC power cord and turn On the printer. The following screen will appear:
Followed by
6. Click Next> to continue
7. Select the top option and then click Next>.
8. Click only the Specify a location: check box. Click on Browse and select the folder in which the drivers are located. C:\Seagull\DatamaxONeil\R13\Datamax-ONeil.
9. Click Next>.
10. The screen to the right will appear confirming the location of the drivers; click Next>.
11. Click Finish. USB printing support has now been installed.
12. Now Windows will install the specific printer driver for your printer. (Windows should find and install the printer driver automatically; however, if you are prompted for a location, the drivers are in the :\Seagull\Datamax-ONeil\R13\Datamax-ONeil folder.)
Possible Errors
If an error message was encountered during the printer driver installation, take these steps: 1. 2. 3. 4. 5. 6. Turn off the printer. Shutdown the PC. Power-up the printer. Power-up the PC. Restart Windows . If needed, go to Step-by-Step Installation and retry the installation.
Difficulty when trying to Print
The Help File, accessible from within your printer driver, includes a Troubleshooting section, which contains a sub-section called Troubleshooting Printing Problems. If you encounter difficulties, here you will find a list of critical settings to check as well as a number of printing tests that will usually get you up and running quickly.
