Scribd
Upload
91 views

Center Console

Upper and lower center finish panels are removed as one assembly. Pry out the upper center finish panel to disengage the clips. Disconnect the electrical connectors.

Uploaded by

John J Taverner
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
91 views

Center Console

Upper and lower center finish panels are removed as one assembly. Pry out the upper center finish panel to disengage the clips. Disconnect the electrical connectors.

Uploaded by

John J Taverner
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

501-12-1

Instrument Panel and Console

501-12-1

REMOVAL AND INSTALLATION


Instrument Panel Center Finish Panel
Removal and Installation
All vehicles 1. Place the vehicle in NEUTRAL. 6. 5. NOTE: The upper and lower center finish panels are removed as one assembly. Using a suitable tool, gently pry out the upper center finish panel to disengage the clips. Disconnect the electrical connectors.

MKX only 2. Remove the floor console trim ring. 7.

Using a suitable tool, gently pry out the lower center finish panel to disengage the clips. Disconnect the electrical connectors.

Separate the upper finish panel from the lower finish panel.

Edge only 8. NOTE: The upper and lower center finish panels are removed separately. Using a suitable tool, gently pry out the upper center finish panel to disengage the clips and remove the panel. 9. All vehicles 3. Remove the floor console finish panel. Open the storage compartment door. Remove the console finish panel. Disconnect the electrical connectors.

Using a suitable tool, gently pry out the lower center finish panel to disengage the clips and remove the panel. Disconnect the electrical connectors.

All vehicles 10. To install, reverse the removal procedure.

MKX only 4. Remove the storage bin. Remove the 2 scrivets. Disconnect the power point electrical connector.

Copyright 2006, Ford Motor Company


Last updated: 10/30/2006

2007 Edge, MKX, 1/2007

You might also like