Scribd
Upload
79 views

STC Universal Programmer: Brief Introduction

The STC Universal Programmer can program all STC microcontrollers. It has both RS-232 and USB ports for connectivity and uses a jumper to select the connection mode. A switch allows selecting between 5V and 3.3V power for different devices. External ports enable programming non-DIP devices or boards with STC microcontrollers. Onboard resources include converters, sockets, and a power supply. Operating instructions guide downloading drivers, connecting the programmer, selecting options in STC ISP software, setting voltage, choosing a hex file, and programming/removing the chip.

Uploaded by

7031665
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
79 views

STC Universal Programmer: Brief Introduction

The STC Universal Programmer can program all STC microcontrollers. It has both RS-232 and USB ports for connectivity and uses a jumper to select the connection mode. A switch allows selecting between 5V and 3.3V power for different devices. External ports enable programming non-DIP devices or boards with STC microcontrollers. Onboard resources include converters, sockets, and a power supply. Operating instructions guide downloading drivers, connecting the programmer, selecting options in STC ISP software, setting voltage, choosing a hex file, and programming/removing the chip.

Uploaded by

7031665
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

STC Universal Programmer

Brief introduction
The STC Universal Programmer is the only programmer that can work for all STC micro-controllers. The programmer has both RS-232 port and USB port. USB is also used as power supply port. Programmer can be configured to work in either RS-232 mode or USB mode port through jumper. The programmer works for both normal voltage (5V) and low voltage (3.3V) devices. The working voltage can be configured through a switch. There are two external ports on the programmer. They could be used to program Non-DIP devices or STC microcontroller devices on other boards.

On-board resources
RS233-TTL Level convertor SP3232E USB-UART Bridge PL2303 One 40pintwo 28pin zip IC socket 5V/3.3V power supply Power On/Off Switch 4bits DIP switch for settings Two 6pins external connectors

http://www.siliconray.com/development-boards.html

Operating instructions
1 Install USB drive. Driver can be downloaded here: http://www.stc-51.com/devtools/PL-2303.exe 2 Use USB or RS-232 cable to connect PC and programmer. 3 Move STC ISP software and set up relevant options. Software can be downloaded

here: http://www.stc-51.com/softwares.php 4 Make sure power supply is off. Plug chip in correct place of Zip socket and choose proper supply voltage for the device. 5 Choose hex file to be programmed, click program button in ISP Software to program. 6 After programming, turn off power supply and take down the chip.
Programmer setting P01P11 setting

Chip mount

You might also like