0% found this document useful (0 votes)
170 views2 pages

Bài tập Static Routing

This document discusses configuring static routes for routers in a network. It instructs to first configure individual static route entries for each subnet. Then to rewrite the routes to use the minimum number of entries while still reaching all subnets. Finally, it asks to configure the routers with load balancing and floating static routes to make use of equal cost paths and provide redundancy.

Uploaded by

Bảo Bình
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
170 views2 pages

Bài tập Static Routing

This document discusses configuring static routes for routers in a network. It instructs to first configure individual static route entries for each subnet. Then to rewrite the routes to use the minimum number of entries while still reaching all subnets. Finally, it asks to configure the routers with load balancing and floating static routes to make use of equal cost paths and provide redundancy.

Uploaded by

Bảo Bình
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

Bi tp Static Routing

1. Configure static routes for each router of the network shown in Figure below. Write the routes so that every
subnet has an individual entry.

2. Rewrite the static routes created in Configuration Exercise 1 to use the minimum possible route entries. 3. For the network shown in Figure below, write static routes for each router. Assume that all links are identical
media. Use load balancing on equal cost paths and floating static routes for maximum efficiency and redundancy.

You might also like