Scribd
Upload
59 views

As Table

The document provides instructions for implementing a 555 timer integrated circuit as an astable multivibrator. It lists the required components, gives the design formula for calculating the output frequency, outlines the wiring procedure and adjusting the duty cycle using a potentiometer, and notes that the results should include measuring the amplitude and pulse width of the output square wave.

Uploaded by

Avinash Nandakumar
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
59 views

As Table

The document provides instructions for implementing a 555 timer integrated circuit as an astable multivibrator. It lists the required components, gives the design formula for calculating the output frequency, outlines the wiring procedure and adjusting the duty cycle using a potentiometer, and notes that the results should include measuring the amplitude and pulse width of the output square wave.

Uploaded by

Avinash Nandakumar
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

08.

408 Analog Integrated circuits Lab Manual Astable multivibrator using 555 timer IC Aim: To test and implement 555 timer IC as an astable multivibrator Components required : CRO (20Mhz ,dual channel) Resistors Signal generator Oscilloscope probes 555 timer, capacitors,multimeters

Design fo=1/T, 1.45/(Ra+2Rb)C Where fo= output frequency Procedure: a) Wire the circuit as shown in figure b) Vary the pot to adjust the duty cycle of the astable output on CRO c) Plot the output waveforms and record the result

Dept of ECE,VKCET

08.408 Analog Integrated circuits Lab Manual Result:The amplitude of the square wave astable output = .... V The pulse width of the output square pulse =........ms

Dept of ECE,VKCET

You might also like