Scribd
Upload
144 views

Boss Design

Bosses are used for the purpose of registration of mating parts or for attaching fasteners such as screws or accepting threaded inserts. The wall thicknesses should be less than 60 % of nominal wall to minimize sinking. The maximum insertion force F max and the maximum hoop stress, ocurring at the inner diameter of the boss, max is given by.

Uploaded by

Peeter Kurg
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
144 views

Boss Design

Bosses are used for the purpose of registration of mating parts or for attaching fasteners such as screws or accepting threaded inserts. The wall thicknesses should be less than 60 % of nominal wall to minimize sinking. The maximum insertion force F max and the maximum hoop stress, ocurring at the inner diameter of the boss, max is given by.

Uploaded by

Peeter Kurg
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3
Boss Design * Bosses are used for the purpose of registration of mating parts or for attaching fasteners such as screws or accepting threaded inserts (molded-in, press-fitted, ultrasonically or thermally inserted) ‘© The wall thicknesses should be less than 60 % of nominal wall to minimize sinking, However, if the boss is not in a visible area, then the wall thickness can be increased to allow for increased stresses imposed by self-tapping screws. * The base radius should be a minimum of 0.25 x thickness RADIUSED TO PREVENT CORE PIN BURNING RB 0.25T o.6T ‘TO MINIMIZE SINKS BOSS DESIGN GUIDELINES * The boss can be strengthened by gussets at the base, and by attaching it to nearby walls with connecting ribs. BOSS STRENGTHENING TECHNIQUES * Hoop stresses are imposed on the boss walls by press fitting or otherwise inserting inserts. The maximum insertion (or withdrawl) force F,,,,,and the maximum hoop stress, curring at the inner diameter of the boss, ¢,,,, i5 given by where, INSERTION OF INSERT eax = Maximum Insertion/ Withdraw Force INTO A BOSS (ignoring effects of static/dynamic friction and assum ing constant friction) Maximum Hoop Stress (happens tabe at the inner diameter of the boss) Outer Diameter af boss Inner Diameter af boss Poisson Ratia of the boss ‘Young's Modulus of the boss ‘Young's Modulus of the insert Poisson Ratio of the insert Cosfficient of friction, usually ranges from 0.38 to 0.85 for most plastics Interference on Diameters, Q — J Outer Diameter af Insert Lenath of engagement « Failures of a boss are usually attributable to’ High hoop stresses caused because of too much interference of the internal diameter with the insert (or screw). Knit lines -these are cold lines of flow meeting at the boss from opposite sides, causing weak bonds, These can split easily when stress is applied. Knit lines should be relocated away from the boss, if possible. If not possible, then a supporting gusset should be added near the knit line, KNIT LINE FAILURE KNIT LINE STRENGHTHENING TECHNIQUE

You might also like