Scribd
Upload
34 views

Fire Protection System

The fire protection system document outlines steps to take when the alarm sounds, including pressing "Alarm Silence" to stop the bell, "Buzzer Mute" to mute internal sounds, and "Master Reset" after the cause is addressed. It notes that pressing "Buzzer Mute" can stop internal sounds during a power failure. The document also describes worst case scenarios where a "Break Glass" would activate the panel if a zone fault occurs but the panel does not respond, and that different zones would trigger different alarms and responses.

Uploaded by

Anjal Zam
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
34 views

Fire Protection System

The fire protection system document outlines steps to take when the alarm sounds, including pressing "Alarm Silence" to stop the bell, "Buzzer Mute" to mute internal sounds, and "Master Reset" after the cause is addressed. It notes that pressing "Buzzer Mute" can stop internal sounds during a power failure. The document also describes worst case scenarios where a "Break Glass" would activate the panel if a zone fault occurs but the panel does not respond, and that different zones would trigger different alarms and responses.

Uploaded by

Anjal Zam
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

FIRE PROTECTION SYSTEM

SYSTEM OPERATION
When alarm bell sounds
Steps
1. Press "Alarm Silence" to Stop the Alarm bell.
2. Press "Buzzer Mute" to mute the internal buzzer.
3. Press "Master Reset" when cause of alarm is detected and
solved
In case of power failure, internal buzzer may sound and to stop it
 Press "Buzzer Mute"
Note: After restoration of power supply, the panel will be reset
automatically.
In worst Case:
 If there is a Fault in a Zone, but no response from Fire Panel to
Action, then Press the “Break Glass” of that Zone and the Panel
will be Active.

 If Fault occur in Zone1, not in Zone2 then the Alarm Bell will
make sound, LED of Zone1 and “EVACUATE” Sign will Flash.
Use Fire Extin. Cylinder to Suppress Fire. Press “Reset” button to
stop bell.

 If both Zone Trigger then after 30sec. the Fire Suppr. Cylinder
release the Gas.

 Do not Enter in the room until the “EVACUATE” Sign disappear


Of that Zone.

You might also like