Scribd
Upload
42 views

Configuration Guide Lines in New Modems: 1. IP Addresses of CPE: A) On Ethernet Port: 192.168.1.1

This document provides configuration guidelines for new T-KD 318-EUI modems with firmware version R1.00B02.3AS.BL. It outlines that the modem has two IP addresses, 192.168.1.1 for the Ethernet port and 192.168.1.2 for the USB port. It recommends setting the computer's IP address manually between 192.168.1.3 to 192.168.1.34 if needed. It also provides instructions for installing the USB driver and setting the TCP/IP properties for either connection type. Finally, it mentions saving the configuration and outlines settings for firewall, PPPoE, and bridge modes.

Uploaded by

Akash Gyanchandani
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
42 views

Configuration Guide Lines in New Modems: 1. IP Addresses of CPE: A) On Ethernet Port: 192.168.1.1

This document provides configuration guidelines for new T-KD 318-EUI modems with firmware version R1.00B02.3AS.BL. It outlines that the modem has two IP addresses, 192.168.1.1 for the Ethernet port and 192.168.1.2 for the USB port. It recommends setting the computer's IP address manually between 192.168.1.3 to 192.168.1.34 if needed. It also provides instructions for installing the USB driver and setting the TCP/IP properties for either connection type. Finally, it mentions saving the configuration and outlines settings for firewall, PPPoE, and bridge modes.

Uploaded by

Akash Gyanchandani
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 8

Configuration Guide Lines in New Modems

(Model NO.: T-KD 318-EUI)


(Current Firmware Version :  R1.00B02.3AS.BL)

1. IP addresses of CPE: a) On Ethernet Port: 192.168.1.1


b) On USB Port : 192.168.1.2

i.e. Two IP addresses are allotted to ADSL Router(CPE), Hence IP address


to be configured to computer (TCP/IP properties) will be:

From: 192.168.1.3 To: 192.168.1.34

2. TCP/IP properties setting on computer.

a) Obtain IP address automatically. It will OK.


b) If you want to assign IP address to Compter manually then:

IP address: 192.168.1.3

Subnet Mask: 255.255.255.0

Default Gateway: 192.168.1.1 …………. For Ethernet Port


Or 192.168.1.2 ……... For USB Port

Primary DNS: 203.94.243.70


Secondary DNS: 203.94.227.70

Guidelines to install USB Driver:-


1. First start installing USB Driver.
2. During the installation process, you will be asked to connect the
ADSL Router Through USB port.
3. Than connect the Router Physically to your
Computer/Laptop
TCP/IP properties Setting:
CASE –I
Abtain IP address Automatically:
CASE II: Use the following IP addresses.

TCP/IP Properties Setting for USB:


TCP/IP Properties Setting for Ethernet:
CPE configuration in PPPoE Mode

Parameters Existing Settings Required Settings


Connection Type PPPoA VC Mux PPPoE LLC
Default Route Disabled Enabled
NAT Disabled Enabled
CPE configuration in Bridge Mode:
Command to Save the configuration

Tools -> Misc -> Save & Reboot, as shown below


Setting in Firewall:

You might also like