Scribd
Upload
33 views4 pages

CE-112L: Engineering Drawing For Civil Engineers (Lab) Spring 2016

Sectional views show the internal surfaces of an object by imagining a cut through the object. Sectional views do not contain any hidden lines. Cutting plane lines define the cut and have arrowheads pointing away from the view. Section lines are thin, inclined lines that vary pattern to distinguish different cut parts. Labeling cutting planes is important with multiple section views.

Uploaded by

abuzar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
33 views4 pages

CE-112L: Engineering Drawing For Civil Engineers (Lab) Spring 2016

Sectional views show the internal surfaces of an object by imagining a cut through the object. Sectional views do not contain any hidden lines. Cutting plane lines define the cut and have arrowheads pointing away from the view. Section lines are thin, inclined lines that vary pattern to distinguish different cut parts. Labeling cutting planes is important with multiple section views.

Uploaded by

abuzar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

CE-112L: Engineering Drawing for Civil Engineers (Lab)

Spring 2016

WEEK 13
Sectional views
Sectional views are used to expose the internal surfaces of an object that would otherwise be hidden from
direct view. Sectional views greatly add to the clarity of the drawing because they DO NOT CONTAIN ANY
HIDDEN LINES.

Cutting plane lines are used to define


the line along which an object is to
be cut. They should be drawn using
heavy and black cutting plane lines.
The arrowheads of a cutting plane
line indicate the direction in which to
observe the sectional view. Think of
yourself as standing on the cutting
plane line looking at the object being
drawn. The arrowheads should point
in the direction in which you are
looking-away from the sectional
view. The cutting plane will be
vertical if the arrowheads are
horizontal, and vice versa.
As shown in the figure, a floor plan is actually a section view of the building, an imaginary cut is made at lintel
level, which passes through all windows and doors. The floor plan shows what is left when the top is removed.
Section lines are used to indicate where, in a sectional view, solid material has been cut. The most common
section line pattern contains thin and black lines inclined at 45 degrees. When two or more parts are cut by
the same cutting plane line, the section cut lines must be varied to indicate clearly the different parts. Do not
Engr. Arsalaan Khan

Page I of IV

CE-112L: Engineering Drawing for Civil Engineers (Lab)


Spring 2016

draw section lines in such a way that they become parallel to any surface in the object. If the section lines
drawn at 45 degrees become parallel to any surface in the object, the angle should be changed to 30 degrees
or 60 degrees.

Labeling the cutting planes is very important in case when more than one sectional views of the object are
drawn.

Engr. Arsalaan Khan

Page II of IV

CE-112L: Engineering Drawing for Civil Engineers (Lab)


Spring 2016

Sheet No. 12
B

* Scale= 1.5x

Engr. Arsalaan Khan

Page III of IV

CE-112L: Engineering Drawing for Civil Engineers (Lab)


Spring 2016

* Scale= 1.5x

Engr. Arsalaan Khan

Page IV of IV

You might also like