Scribd
Upload
392 views

DRAGON WAVE Configuration Steps

The document discusses enabling alignment mode on a device by issuing the "Set Alignment on" command via telnet. It also mentions configuring QoS by first completing steps 12, 13 and 14 before proceeding with step 1 and onwards.

Uploaded by

Meharban Lodhi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
392 views

DRAGON WAVE Configuration Steps

The document discusses enabling alignment mode on a device by issuing the "Set Alignment on" command via telnet. It also mentions configuring QoS by first completing steps 12, 13 and 14 before proceeding with step 1 and onwards.

Uploaded by

Meharban Lodhi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Now Enable Alignment mode by issuing below command from Telnet

Set Alignment on
After Alignment configuration

HAAM

In QOS, First Configure Step no 12, 13 & 14 than do the Step 1 Onward

You might also like