Scribd
Upload
666 views12 pages

Concrete Block Sizes & Shapes

This document provides specifications for concrete masonry units (CMU) from Allied Concrete Co. It includes: 1. General specifications for CMU sizes within tolerances and special shapes as needed. 2. Requirements for hollow and solid load-bearing CMU to meet ASTM C90 standards for lightweight or normal weight aggregates and minimum compressive strength of 1900 psi. 3. Requirements for concrete building brick to meet ASTM C55 standards and provide minimum compressive strength to meet performance requirements.

Uploaded by

ecruz_yhwh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
666 views12 pages

Concrete Block Sizes & Shapes

This document provides specifications for concrete masonry units (CMU) from Allied Concrete Co. It includes: 1. General specifications for CMU sizes within tolerances and special shapes as needed. 2. Requirements for hollow and solid load-bearing CMU to meet ASTM C90 standards for lightweight or normal weight aggregates and minimum compressive strength of 1900 psi. 3. Requirements for concrete building brick to meet ASTM C55 standards and provide minimum compressive strength to meet performance requirements.

Uploaded by

ecruz_yhwh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 12

ALLIED

CONCRETE

CO.

1000 HARRIS STREET P.O. BOX 1647

CHARLOTTESVILLE, VIRGINIA 22902

CONCRETE BLOCK
SIZES AND SHAPES

TABLE OF CONTENTS
Specifications For CMU.................................................................. 3
Blocks 2, 3 and 4........................................................................4
Blocks 6..........................................................................................5
Blocks 8..........................................................................................6
Blocks 10 and Miscellaneous........................................................7
Blocks 12 and 14..........................................................................8
Blocks Split Face............................................................................. 9
Blocks Split Face w/ Corner Details..............................................10
Embossed Brick Face.....................................................................11
Estimating Guides and Volumes.................................................... 12

Specifications For Concrete Masonary Units


Concrete Masonary Units
A. General: Comply with the requirements Indicated Below.
1. Size:
Provided concrete masonary units complying with requirements indicated below for
size are manufactured to specified face dimensions within tolerances specified in
applicable referenced ASTM specification.
A. Manufacture concrete masonary units specified dimensions of 3/8 inch less than
nominal widths by nominal heights by nominal lenghts.

2. Provide special shapes where indicated and as follows:


A. For Lintels, corners, jambs, sash, control joints, headers, bonding and other special
conditions
B. Square-edged units for outside corners except where bullnose units are indicated.

B. Hollow and solid load-bearing concrete masonary units:


ASTM C 90 and as Follows:
A. Type II
B. Weight Classifications: lightweight (maximum density of less than 105 PCF) and a
maximum linear drying shrinkage of 0.065% when tested in accordance with ASTM
C 426. Fabricate using lightweight aggregate that strictly conforms to ASTM C
331. Normal weight aggregates, when used in blending with lightweight aggregates
to achieve a smooth, tight texture, shall conform to ASTM C 33.
C. Unit compressive strength not less than 1900 psi average net area to provide system
performance requirement of FM 1500.
C. Concrete building brick: ASTM C 55 and as Follows:
A. Unit compressive strength: provide units with minimum average net area
compressive strength to meet systems performance requirements.

You might also like