Scribd
Upload
9 views

Lecture - 7

1) This document discusses methods for analyzing axially loaded members, including determining displacement, internal forces using compatibility equations, and stress. 2) It provides an example of calculating the modulus of elasticity and diameter change of an aluminum specimen under an axial load. 3) Another example calculates the displacement of a rigid beam resting on posts made of different materials when a vertical load is applied.

Uploaded by

Ronaldo Hertez
Copyright
© © All Rights Reserved
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
9 views

Lecture - 7

1) This document discusses methods for analyzing axially loaded members, including determining displacement, internal forces using compatibility equations, and stress. 2) It provides an example of calculating the modulus of elasticity and diameter change of an aluminum specimen under an axial load. 3) Another example calculates the displacement of a rigid beam resting on posts made of different materials when a vertical load is applied.

Uploaded by

Ronaldo Hertez
Copyright
© © All Rights Reserved
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 16

Lecture - 7

1) To determine the displacement of


axially loaded member.
2) To find internal forces using
compatibility equations.
3) To determine stress within axially
loaded members.

The Shear Stress-Strain Diagram


G

E
21

Example:
An aluminum specimen shown in figure has
a diameter of d0 = 25mm and a gauge length
of L0 = 250mm. If a force of 165kN elongates
the gauge length of 1.20mm, determine the
modulus of elasticity. Also, determine by how
much the force causes the diameter of the
specimen to contact. Take Gal = 26 GPa and
= 440 MPa.

Solution:

Example:
A rigid beam AB rests on the two short posts as shown in
figure, AC is made of steel and has a diameter of 20mm,
and BD is made of aluminum and has a diameter of 40mm.
Determine the displacement of point F on AB if a vertical
load of 90 kN is applied over this point. Take Est = 200 GPa,
Eal = 70 GPa.

Solution:

Statically Indeterminate Axially Loaded Member

FB + F A P = 0
A/B = 0

Example:

The aluminum post as shown in figure is


reinforced with a brass core. If this
assembly supports a resultant axial
compressive load of P = 45kN, applied
to the rigid cap, determine the average
normal stress in the aluminum and the
brass. Take Eal = 70 (103) MPa and Ebr =
105 (103) MPa.

Solution:

Equilibrium.

- 45 kN + Fal + Fbr = 0

Example:
The three A-36 steel bars as
shown in figure are pin
connected to a rigid member. If
the applied load on the member
is 15 kN, determine the force
developed in each bar. Bars AB
and EF each have a crosssectional area of 25 mm2, and
bar CD has a cross-sectional
area of 15 mm2.

Solution:

You might also like