Scribd
Upload
416 views1 page

D-Link 1504g Firmware Upgrade

The document provides steps to update the firmware of a GSHDSL device using TFTP. The steps are: 1) install TFTP server software and connect the GSHDSL device to the PC with Ethernet and console cables; 2) access the GSHDSL console through HyperTerminal and configure the IP addresses to match the PC; 3) save the configurations, start the TFTP server, and use TFTP to transfer the new firmware file and burn it to flash, erasing the old firmware.

Uploaded by

VijayKumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
416 views1 page

D-Link 1504g Firmware Upgrade

The document provides steps to update the firmware of a GSHDSL device using TFTP. The steps are: 1) install TFTP server software and connect the GSHDSL device to the PC with Ethernet and console cables; 2) access the GSHDSL console through HyperTerminal and configure the IP addresses to match the PC; 3) save the configurations, start the TFTP server, and use TFTP to transfer the new firmware file and burn it to flash, erasing the old firmware.

Uploaded by

VijayKumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Step 1: Install any TFTP server software.

Step 2:Connect GSHDSL to your PC with one Ethernet cable and also with console
cable.
Step 3:Open PCs HyperTerminal, select baud rate as 115200. Power on GSHDSL.
Step 4:When you see the message Hit any key to stop auto boot: , please hit any key.
Step 5:The HyperTerminal window will show =>, then you can use the command
printenv to view the parameters.
Step 6:Type setenv serverip xxx.xxx.xxx.xxx, the same IP address as your PC IP
address.
Step 7:Type setenv ipaddr xxx.xxx.xxx.yyy, pls make sure the IP address is in the
same subnet with your PC.
Step 8:You can type the command printenv to see whether you have made the correct
IP address changes.
Step 9: Type save to save your configurations.
Step 10:Run the TFTP server software , set the path of the default directory to where you
put the new bootloader file.
Step 11: Type tftp 100000 Tcomimg_2.6-505-1.3-QA66singleplus-L2
,(ushould change the firmware name) then you will see loading message.
Step 12: After loading file, type erase 2840000 2cfffff to erase the old file in the flash
Step 13: Type cp.b 100000 2840000 $(filesize) to burn the file to the flash.
Step 14: Type reset

You might also like