Scribd
Upload
89 views

BROCADE Useful Commands To Monitoring and Status

This document provides examples of Brocade commands used to monitor network status and configuration. It shows commands for pinging an IP address, displaying IP and FC tunnel interfaces, ARP entries, port status, mode and attached switches. The commands provide information on IP and FC routing tables, tunnel configurations and health, attached switches and their interconnections.

Uploaded by

Srinivas Kumar
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
89 views

BROCADE Useful Commands To Monitoring and Status

This document provides examples of Brocade commands used to monitor network status and configuration. It shows commands for pinging an IP address, displaying IP and FC tunnel interfaces, ARP entries, port status, mode and attached switches. The commands provide information on IP and FC routing tables, tunnel configurations and health, attached switches and their interconnections.

Uploaded by

Srinivas Kumar
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

BROCADE Useful Commands to monitoring and status

> portcmd --ping ge0 -s 10.255.2.3 -d 10.255.2.4


Pinging 10.255.2.4 from ip interface 10.255.2.3 on 0/ge0 with 64 bytes of data
Reply from 10.255.2.4: bytes=64 rtt=12ms ttl=64
Reply from 10.255.2.4: bytes=64 rtt=12ms ttl=64
Reply from 10.255.2.4: bytes=64 rtt=12ms ttl=64
Reply from 10.255.2.4: bytes=64 rtt=12ms ttl=64
Ping Statistics for 10.255.2.4:
Packets: Sent = 4, Received = 4, Loss = 0 ( 0 percent loss)
Min RTT = 12ms, Max RTT = 12ms Average = 12ms
> portshow ipif ge0
Port: ge0
Interface IP Address NetMask MTU
0 10.255.2.3 255.255.255.0 2250
> portshow ipif ge1
Port: ge1
Interface IP Address NetMask MTU
0 10.255.2.5 255.255.255.0 2250
> portshow iproute ge0
Port: ge0
IP Address Mask Gateway Metric Flags
10.255.2.0 255.255.255.0 10.255.2.3 0 Interface
> portshow iproute ge1
Port: ge1
IP Address Mask Gateway Metric Flags
10.255.2.0 255.255.255.0 10.255.2.5 0 Interface
> portshow fciptunnel ge0 all
Port: ge0
Tunnel ID 0
Remote IP Addr 10.255.2.4
Local IP Addr 10.255.2.3
Remote WWN Not Configured
Local WWN 10:00:00:05:1e:38:12:e4
Compression on
Fastwrite on
Tape Pipelining on
Committed Rate 636928 Kbps (0.636928 Gbps)
SACK on
Min Retransmit Time 100
Keepalive Timeout 10
Max Retransmissions 8
Status : Active
Uptime 19 hours, 11 minutes, 2 seconds
> portshow fciptunnel ge1 all
Port: ge1

Tunnel ID 0
Remote IP Addr 10.255.2.6
Local IP Addr 10.255.2.5
Remote WWN Not Configured
Local WWN 10:00:00:05:1e:38:12:e4
Compression on
Fastwrite on
Tape Pipelining on
Committed Rate 636928 Kbps (0.636928 Gbps)
SACK on
Min Retransmit Time 100
Keepalive Timeout 80
Max Retransmissions 9
Status : Active
Uptime 19 hours, 11 minutes, 13 seconds
> portshow arp ge0
Port: ge0
IP Address Mac Address Flags
10.255.2.4 00:05:1e:37:f2:e0 Resolved
> portshow arp ge1
Port: ge1
IP Address Mac Address Flags
10.255.2.6 00:05:1e:37:f2:e1 Resolved
> portshow ge0
Eth Mac Address: 00.05.1e.38.12.c8
Port State: 1 Online
Port Phys: 6 In_Sync
Port Flags: 0x3 PRESENT ACTIVE
Port Speed: 1G
> portshow ge1
Eth Mac Address: 00.05.1e.38.12.c9
Port State: 1 Online
Port Phys: 6 In_Sync
Port Flags: 0x3 PRESENT ACTIVE
Port Speed: 1G
> portshow mode ge0
Port: ge0
Mode: FCIP
> portshow mode ge1
Port: ge1
Mode: FCIP
> fcrfabricshow
FC Router WWN: 10:00:00:05:1e:38:12:e4, Dom ID: 50, Info: 10.236.190.51,
"fcrap14c001"
EX_Port FID Neighbor Switch Info (WWN, enet IP, name)

4 30 10:00:00:05:1e:35:2c:9d 10.236.189.121 "fcsap14c301"


FC Router WWN: 10:00:00:05:1e:37:f2:fc, Dom ID: 51, Info: 10.12.23.194,
"fcrrp21001"
EX_Port FID Neighbor Switch Info (WWN, enet IP, name)
4 31 10:00:00:05:1e:03:11:e1 10.12.23.188 "fcsrp21001"
> fcrresourceshow
Daemon Limits:
Max Allowed Currently Used
LSAN Zones: 3000 0
LSAN Devices: 10000 0
Proxy Device Slots: 10000 0
WWN Pool Size Allocated

You might also like