Scribd
Upload
69 views1 page

Creep Waves: Creep Waves Are High Angle Ultrasonic Longitudinal Waves. The Creeping Wave Is Actually The Upper Part of

Creep waves are high angle ultrasonic longitudinal waves that propagate just under a component's surface and are sensitive to shallow surface-breaking cracks. They rapidly lose energy as head waves but these can reconvert to creep waves at inner surfaces, making them sensitive to inner surface cracks parallel to the surface. Creep waves are less attenuated in austenitic and inconel weld metals than shear waves, giving them an advantage over shear waves for inspecting these materials.

Uploaded by

cal2_uni
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
69 views1 page

Creep Waves: Creep Waves Are High Angle Ultrasonic Longitudinal Waves. The Creeping Wave Is Actually The Upper Part of

Creep waves are high angle ultrasonic longitudinal waves that propagate just under a component's surface and are sensitive to shallow surface-breaking cracks. They rapidly lose energy as head waves but these can reconvert to creep waves at inner surfaces, making them sensitive to inner surface cracks parallel to the surface. Creep waves are less attenuated in austenitic and inconel weld metals than shear waves, giving them an advantage over shear waves for inspecting these materials.

Uploaded by

cal2_uni
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Creep Waves

Creep Waves are high angle ultrasonic longitudinal waves. The creeping wave is actually the upper part of
the envelope of a 76 degree compression wave beam which propagates just under the component
surface, see Figure. These are not true surface waves and the energy is concentrated within a few
millimetres of, and almost parallel to, the surface. Hence, the technique is very sensitive to shallow
surface-breaking cracks whilst at the same time being relatively insensitive to surface condition.

The maximum working range is typically 45 mm in front of the probe because the creep wave rapidly loses
energy in the form of 33 indirect shear, or 'head', waves as it propagates. However, these head waves will
re-convert to a creep wave at the inner surface of the component. Like the top surface creep wave, this
inner surface creep wave is very sensitive to inner surface breaking cracks and as it runs parallel to the
inner surface it will not be sensitive to the presence of weld roots.
Creep waves have the advantage that, being longitudinal waves, they are far less attenuated in austenitic
and inconel weld metal than shear waves.
What the hec?! articles are not intended to be the definitive account on the topic or acronym in question.
Readers comments and contributions are welcomed. Email: [email protected]

http://www.bindt.org/What-is-NDT/Index-of-acronyms/Creep-Waves/

You might also like