Scribd
Upload
440 views

Aurora Papercraft Printable 0210 FDCOM

This document provides instructions for assembling a papercraft doll of the Disney princess Aurora by printing out the pieces, cutting them out, folding along dashed lines, and gluing tabs onto designated areas to form the torso, arms, chest, and skirt.

Uploaded by

mec4
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
440 views

Aurora Papercraft Printable 0210 FDCOM

This document provides instructions for assembling a papercraft doll of the Disney princess Aurora by printing out the pieces, cutting them out, folding along dashed lines, and gluing tabs onto designated areas to form the torso, arms, chest, and skirt.

Uploaded by

mec4
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

AuroraPapercraft

ey

sn

Di

D
F

chest

H
Disney

Disney

Disney

torso

back

rightarm

leftarm

skirt

C
Disney
Page1of2

AuroraPapercraft
1. Print out your princess on regular paper or cardstock. Cut out each piece with a craft knife or scissors.
Do not cut along the dashed lines -- this is where you will fold the paper.
2. Line up Auroras back with her torso and glue them together so that the design is now two-sided. After
the glue has dried, fold the bottom part of Auroras torso towards you along the bottom dashed line. Then, fold
Auroras face away from you on the top dashed line across her shoulders.
3. Take Auroras chest piece and fold along each dashed line. Make each fold away from you.
4. Spread glue on the D tab of Auroras chest and press it into place on the D area on Auroras torso. Make sure
her shoulders are lined up correctly.
5. After the glue dries, add glue to the F, G, H, and I tabs and press them into place. Hold the pieces together
until the glue dries. You may need to use a pen or pencil inside her chest area to position the tabs just right.
6. Fold each of Auroras arms and glue them so that the design is two sided. Make sure they are lined up
before the glue dries. Attach the arms to each side of Auroras body under each shoulder by gluing the B
tab to the B area and C tab to the C area.
7. Glue Auroras skirt so that it makes the shape of a cone.
8. Finally, attach Auroras completed torso to her skirt by gluing the white side of the tabs at her waist to the
top of the skirt.

Disney
Page2of2

You might also like