Scribd
Upload
39 views

Adsorbent Simulation Request

simulation of adsorber

Uploaded by

Kvspavan Kumar
Copyright
© © All Rights Reserved
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
39 views

Adsorbent Simulation Request

simulation of adsorber

Uploaded by

Kvspavan Kumar
Copyright
© © All Rights Reserved
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

May 2006

Adsorbent Simulation Request


NOTES:
a.
b.

Prospective Client is requested to provide/ fill-in data demarcated in RED/ with an asterix (* & **) below
Data at (**) is required from the Client to know of any limiting conditions/ processing objectives to be
adhered to while simulating. If none is specified, UOP shall design based on what is achievable.
For your information, a typical output from UOP would provide the balance details (as applicable)

c.

End User:
Location:
Design Basis:

Design Summary No.


Date:
Contractor (if any):
FEED

PRODUCT

PURGE GAS
(HEATING)

PURGE GAS
(COOLING)

Flow Rate (kg/ hr)

11426

11384

3829

3829

Pressure (kg/ cm 2 g)

77.93

77.93

4.5

4.5

Temperature (C)

49.3

49.3

220

52.1

Density (kg/ m )

26.68

26.68

2.3

3.5

Molecular Weight

9.93

9.93

21.21

21.21

Hydrogen

1538

1538

66

66

Nitrogen

7170

7170

2591

2591

Argon

1169

1169

482

482

Methane

1506

1506

690

690

Ammonia

0 (< 1 ppm)

Moisture

33

0 (< 1 ppm)

OPERATING CONDITION

Composition
(kg/hr)

PROCESS DESIGN
ADSORPTION

DEPRESSURE

HEAT

COOL

REPRESSURE

360min

15min

135min

180min

15min

Flow Direction

downwards

upward

upward

upward

downwards

Type of Cycle

closed

closed

closed

closed

closed

Flow Rate (kg/hr)

11426

--

3828

3828

--

Temperature (C)

49.3

49.3

220

52.1

49.3

Pressure (kg/cm g)

77.93

From 77.93 to
4.5

4.5

4.5

From 4.5 to
77.93

Pressure Drop (kg/cm 2)

<0.1

--

<0.1

<0.1

<0.1

Time (hours/ bed)

Number of beds: 2 Insulation: 1mm Bed diameter: 1500mm Bed height: 1400mm for adsorbent
Adsorbent requirements:
Bed height allows for ceramic support: NO
Bed Support Ball Requirements: satellite pad at bottom (not required)
Note: Both beds will be in line for 10 minutes.

You might also like