Scribd
Upload
59 views

Air Pollution Control Technology (Ceb 30403) : Name: Theyvan A/L Ganesan

Calibration is comparing measuring equipment to a standard of high accuracy to detect and adjust any inaccuracies. It involves setting the instrument to zero and adjusting the span, or range of values. Calibrations are performed by applying known measured values and recording the instrument's outputs to ensure it provides accurate readings when installed. Control system technicians calibrate systems that measure and control variables like level, temperature, and pressure by following detailed instructions specific to each instrument model and configuration.

Uploaded by

Theyvan T-van
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
59 views

Air Pollution Control Technology (Ceb 30403) : Name: Theyvan A/L Ganesan

Calibration is comparing measuring equipment to a standard of high accuracy to detect and adjust any inaccuracies. It involves setting the instrument to zero and adjusting the span, or range of values. Calibrations are performed by applying known measured values and recording the instrument's outputs to ensure it provides accurate readings when installed. Control system technicians calibrate systems that measure and control variables like level, temperature, and pressure by following detailed instructions specific to each instrument model and configuration.

Uploaded by

Theyvan T-van
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

AIR POLLUTION CONTROL TECHNOLOGY (CEB 30403)

ASSIGNMENT 2

CALIBRATION

NAME : THEYVAN A/L GANESAN

ID

: 55201212141

LECTURER : DR. AMELIA

What
Calibration is a comparison of measuring equipment against a standard instrument of high
accuracy to detect, correlate, adjust, rectify and document the accuracy of the instrument being
compared. It includes the capability to adjust the instrument to zero and to set the desired span.
The zero value is the lower end of the range. Span is defined as the algebraic difference between
the upper and lower range values.

When
A test during which known values of measured are applied to the transducer and corresponding
output readings are recorded under specified conditions.

Why
To make sure the instrument is providing accurate indication or output signal when it is installed.
Since a calibration is performed by comparing or applying a known signal to the instrument
under test, errors are detected by performing a calibration.

Where
These task applied to systems that measure and control level, temperature, pressure, flow, force,
power, position, motion, physical properties, chemical composition and other process variables.

Who
A control system technician (CST) is a skilled craftsperson who knows pneumatic, mechanical,
and electrical instrumentation. He or she understands process control loops and process control
systems, including those that are computer-based. Usually, he or she has received training in such
specialized subjects as theory of control, analog and/or digital electronics, microprocessors
and/or computers, and the operation and maintenance of particular lines of field instrumentation.
A CST performs calibration, documentation, loop checks, troubleshooting, and repair or
replacement of instrumentation.

How
Calibrations should be performed in accordance with detailed instructions. Each different
make/model instrument is adjusted differently. Each instrument is installed in a different physical
and loop configuration. Because of these and many other differences, attention to detail is very
important. The minute a technician is not paying attention to detail, safety and proper
performance are jeopardized.

You might also like