Scribd
Upload
19 views

If SD Drop Is High PLZ Look On Parameters Like

The document provides recommendations for addressing high SD drop issues in a cellular network. It suggests checking for potential hardware issues by looking at TRX condition, path imbalance, VSWR, connector connections and BCCH TRX issues. Interference issues should be investigated by analyzing C/I, Co-BSIC, Co-BCCH, RXP PMAX values and antenna orientation. Network parameters like signaling rates, timers T3100, T200, T11, T305 and T308 should also be reviewed.

Uploaded by

kanthiitu
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
19 views

If SD Drop Is High PLZ Look On Parameters Like

The document provides recommendations for addressing high SD drop issues in a cellular network. It suggests checking for potential hardware issues by looking at TRX condition, path imbalance, VSWR, connector connections and BCCH TRX issues. Interference issues should be investigated by analyzing C/I, Co-BSIC, Co-BCCH, RXP PMAX values and antenna orientation. Network parameters like signaling rates, timers T3100, T200, T11, T305 and T308 should also be reviewed.

Uploaded by

kanthiitu
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

SD_DROP ANALYSIS

If SD drop is high plz look on parameters like

Overshooting
Shift the SD time slot
Hardware issue-Check Alarms.,TRX condition.,Check Path
Imbalance.,VSWR of the Cell.,Connector Connection.
Some times you will find issues on BCCH TRX.In this case BCCH shift
from one to other TRX will reduce SD drop.
Interference: Check the BCCH Plan (C/I or C/A). Co-BSIC & Co
BCCH. Change the values of RXP PMAX
It may be uplink or downlink issue in which cells for UL put a TMA in
that cell and for DL provide tilt
Re orient that antenna.
Use latest ND 111 and MapInfo to find out proper frequency to
reduce interference
High LAPD Utilization:Check LAPD util report from OSS, and define
32 kbps signaling instead of 16kbps

Check for parameter:


Check the Timer T 3101(best at 3secs Immid establishement), Timer T
200(20ms) for LAPDm supervision during a call, leads to call drop,T11
Expired(10 s),MAIO check.
T305 and T308 should not be less than 11sec at the MSC to allow MS (disconnect
and release msgs get to the MSC) hence peg call drop.

You might also like