Scribd
Upload
1K views

MOS Imp Questions

The document contains 7 questions about mechanics of materials concepts such as Hooke's law, stress-strain diagrams, shear force and bending moment diagrams, shear stress and bending theory assumptions. It also includes problems calculating member forces in trusses and frames, stress in a loaded bar, elongation of a steel bar, and determining maximum bending moment from a loaded beam diagram. The questions cover a range of essential mechanics topics for an exam.

Uploaded by

SYED JUNAID AHMED
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
1K views

MOS Imp Questions

The document contains 7 questions about mechanics of materials concepts such as Hooke's law, stress-strain diagrams, shear force and bending moment diagrams, shear stress and bending theory assumptions. It also includes problems calculating member forces in trusses and frames, stress in a loaded bar, elongation of a steel bar, and determining maximum bending moment from a loaded beam diagram. The questions cover a range of essential mechanics topics for an exam.

Uploaded by

SYED JUNAID AHMED
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

mos imp qus

1.A) Define Hookes law and explain its limitations.



B) An alloy circular bar ABCD 3m long is subjected to a tensile force of 50 kN shown in fib. If the
stress in the middle portion BC is not exceed 150 MPa, then what should be its diameter? Also find the
length of the middle portion, if the total extension of the bar should not exceed by 3 mm. Take E as 100
GPa.

2. A) Draw and Explain stress strain diagram of mild steel.
B) Derive the relation between bulk modulus youngs modulus

3. Draw the bending moment and shear force diagram for the beam shown loaded as in figure 1.Mark the
maximum bending moment and also determine its value.

4. A) Derive maximum shear stress variations in the T-section
B) Enumerate assumptions in theory of bending.



5. a) Explain the following terms
1. Stress and strain
2. Youngs modulus
3. Shear stress and shear strain.
b) a steel bar ABCD 4 m long is subjected to forces as shown in fig find the elongation of the
bar. Take E of the steel as 200 GPa.

6. a) Define the following.
1. Bending moment
2. Shear force
3. point of contra flexure
b) A cantilever beam of length 2 m carries an uniformly distri buted load of 3 kN/m over a
length of 1.5 m from its fixed end and a point load 5 kN at its free end. Draw the SFD and BMD.
7. a) Discuss the assumptions involved in theory of simple bending?
b) What is an elastic section modulus?

8. a) Classify pin jointed plan frames?
b) Find the forced in all members of given frame:

You might also like