USBasp Hardware Manual Rev0
USBasp Hardware Manual Rev0
ATmega MCU
J1 J2
Power Indicator
Programming Indicator
Low cost USB programmer for ATMEL AVR microcontrollers with ISP features based on Thomas Fischl USBasp and METALAB AVRProg. This clone implements the AVRProg version that has a 1MHz clock source that users can use to recover chips with wrong clock fuse settings. Supported by the following programming softwares: - AVRDUDE version 5.2 and up. AVRDUDE is the programming software used by the WinAVR development suite. - BASCOM-AVR version 1.11.9.6 and up - Khazama AVR Programmer - eXtreme Burner-AVR - Arduino IDE 1.0 and up.
1 MHZ Output GND MOSI +5V ICSP JP6 Table 1. ICSP Port (JP6)
Pin I.D. 1 MHZ Out MISO +5V SCK MOSI SS GND IC Pin 8&7 16 18 17 15 14 21 IC Pin Function XTAL1 & XTAL2 (MISO)PB4 AVCC (SCK)PB5 (MOSI)PB3 (SS)PB2 AGND
SS SCK MISO