Scribd
Upload
34 views1 page

Extrusion and Wire Drawing 15

This document discusses stresses in rod and wire drawing. It states that in rod and wire drawing there is a cylindrical state of stress where the stresses in the radial y and z directions are equal. It then applies the Von-Mises yield criterion to relate the radial stress to the yield strength of the material.

Uploaded by

Ankit Saha
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
34 views1 page

Extrusion and Wire Drawing 15

This document discusses stresses in rod and wire drawing. It states that in rod and wire drawing there is a cylindrical state of stress where the stresses in the radial y and z directions are equal. It then applies the Von-Mises yield criterion to relate the radial stress to the yield strength of the material.

Uploaded by

Ankit Saha
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

In rod/wire drawing, we have cylindrical state of stress i.e. stresses in y and z direction are equal (radial stress).

So,

Applying Von- Misses yield criterion

Putting

You might also like