Scribd
Upload
29 views

Recipro. Compressor

There are two main types of compressors: reciprocating and rotary. Reciprocating compressors use pistons driven by a crankshaft to compress gases into high pressure, while rotary compressors compress gas through the rotating action of a roller inside a cylinder. Multistage compressors are needed for high pressure rises because they compress air in multiple stages with intercoolers in between each stage to remove heat and allow for higher pressures without excessive temperature increases.

Uploaded by

Bhuneshwar Chelak
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
29 views

Recipro. Compressor

There are two main types of compressors: reciprocating and rotary. Reciprocating compressors use pistons driven by a crankshaft to compress gases into high pressure, while rotary compressors compress gas through the rotating action of a roller inside a cylinder. Multistage compressors are needed for high pressure rises because they compress air in multiple stages with intercoolers in between each stage to remove heat and allow for higher pressures without excessive temperature increases.

Uploaded by

Bhuneshwar Chelak
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Reciprocating compressor

It is a positive-displacement compressor that

Uses pistons driven by a crankshaft to deliver gases at high pressure.


The

intake gas enters the suction manifold, then flows into the compression cylinder
It

gets compressed by a piston driven in a reciprocating motion via a crankshaft,


Discharged at

higher pressure

Rotary compressors
The

gas is compressed by the rotating action of a roller inside a cylinder.


The

roller rotates off-centre around a shaft so that part of the roller is always in contact with the cylinder.
Volume of

the gas occupies is reduced and the refrigerant is compressed.


High

efficient as sucking and compressing refrigerant occur simultaneously.

Why multistage compressor?


High

temp rise leads into limitation for the maximum achievable pressure

rise. Discharge temperature shall not exceed 150C and should not exceed 1350C for hydrogen rich services A multistage centrifugal compressor compresses air to the required pressure in multiple stages. Intercoolers are used in between each stage to removes heat and decrease the temperature of gas so that gas could be compressed to higher pressure without much rise in temperature

Intercooler

You might also like