RF PCB Design

This document discusses considerations for designing a high frequency PCB, including using a 2-layer board, minimizing impedance changes with transmission line traces, proper decoupling techniques such as minimizing current loops and using separate decoupling capacitors for each circuit block, and addressing issues such as parasitic inductance from vias. It also covers transmission line design principles like avoiding reflective features larger than 1/10 wavelength and using tapers or curves only in transition regions.

Uploaded by

Mahima Arrawatia

Available Formats

Download as PPTX, PDF, TXT or read online on Scribd

100% found this document useful (2 votes)

263 views

RF PCB Design

Uploaded by

Mahima Arrawatia

Available Formats

Download as PPTX, PDF, TXT or read online on Scribd

You are on page 1/ 47

High Frequency PCB Design

Typical Transceiver Block

2 layer PCB board

Consideration of the design

Note that the power supply trace on the component is made quite thick so as to present as low as impedance trace as possible. Large areas of ground on this side of the board provide a low impedance path for decoupling. Wherever possible the bottom (copper) side of the board should allow for a solid ground plane under the RF circuitry A 2-layer PCB will be cheaper to manufacture than a 4-layer PCB. However, to implement Microstrip or Stripline transmission lines the PCB thickness should not exceed 0.8mm - 1.00mm (0.031 0.039), since the width of the transmission line trace will become rather large PCBs of this thickness do not generally lend themselves to large sizes because of their fragility.

To overcome this problem with 2-layer designs, try and keep RF circuit traces as short as possible (wavelength< l/30) or for longer traces taper the trace so that the apart from the connection to any multi-footprint component, the trace appears as close to 50ohm as possible

Transmission line on PCB

Current Loops and Decoupling

Minimize current loops on PCB layouts by decoupling as close to the port being decoupled to ground as possible. Try and avoid capacitive coupling by ensuring that each circuit block or port has its own decoupling capacitor. Ensure that each decoupling capacitor has its own via connection to ground. As a rule of thumb, components should not share vias. By minimizing current loops and through careful and considered decoupling it is possible to avoid noise from the noisy circuit blocks, such as the digital blocks, PLL frequency synthesizer and reference oscillator circuit being coupled into highly sensitive circuit blocks such as the LNA and VCO.

Signal return path issues (decoupling)

Every High Frequency input and output
All AC current out/in must return to both nearby supplies
VCC OUT

Load

VEE
Decoupling Capacitor Must be a short at signal frequency

ground path minimum length!

Decoupling caps
10000 pF = 0.01 uF
S11 = reflected/incident power ratio when grounded S21 = ratio of power passed to 50 ohm load

PCB parasitic-- via

Thermal Pad
The multiple vias ensure that the total parasitic inductance associated with the vias is minimized by several parallel connections. In addition, distributed vias ensure an even thermal distribution.

How to use Transmission Lines

Eliminate reflective features larger than 1/10th of a wavelength Avoid impendence changes
45 deg

45 deg
1/10th wavelength

BAD
1/10th wavelength

Non traditional transmission lines (curves, tapers)

If you want to use these features either:
Do it in the transition region between 1/10th and wavelength Or use an RF design tool (e.g., ADS) to verify operation with finite element analysis