0% found this document useful (0 votes)
450 views

RTD Scaler ISP Programming SOP

This document provides standard operating procedures for programming the firmware of a printed circuit board assembly (PCBA) using an in-system programming (ISP) card. It outlines the necessary equipment, software, and steps to connect the PCBA to a PC using an ISP card manufactured by RealTek. The programming process involves opening the DebugTool software, selecting the correct firmware chip manufacturer and model, loading the firmware file, clicking program, and monitoring the progress bar to check if programming was successful.

Uploaded by

pasmanteriabella
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
450 views

RTD Scaler ISP Programming SOP

This document provides standard operating procedures for programming the firmware of a printed circuit board assembly (PCBA) using an in-system programming (ISP) card. It outlines the necessary equipment, software, and steps to connect the PCBA to a PC using an ISP card manufactured by RealTek. The programming process involves opening the DebugTool software, selecting the correct firmware chip manufacturer and model, loading the firmware file, clicking program, and monitoring the progress bar to check if programming was successful.

Uploaded by

pasmanteriabella
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 11

SOP of PCBA ISP Programming -----Manufacturer of Scaler is RealTek

Approved By : Nance Yan


Prepared By: Lucifer Xie
1

Operational condition:
Equipment: PC, ISP card, signal cable and power cable. ESD requirements: antistatic wrists, antistatic gloves (fingers), and connecting cable Name of ISP program: DebugTool_V6.4.exe Manufacture of FW ICRTD 2120

Operational steps:
. Connection: connect PC to PCBA with signal cable, and then keep AC and DC in open state.

signal cable
One port of ISP program card is connected to PC print port.

IF Board or Monitor

.Adjust ISP programming Firstly, double click DebugTool_V6.4.exe and open ISP program, then select RTD2120, and ISP button.

Click ISP button

Figure 1
4

Secondlyselect Bank2 size which is 30.

Figure 2

Select Bank2 size: 30


5

Thirdly, click 64Kbutton and load FW file,and it will load extend FW automatically as below Figure 3.

Figure 3
6

Fourthly, click programbutton as below,then you will see the Checksum. Figure 4 .

Figure 4

Click this button to program


7

Fifthly,Program process as below.

Figure 5

Note: Please see the configure as below Figure 6.

Configure Inform

Figure 6


After connecting, AC ON, DC ON OK Open ISP program OK
Choose manufacturer and model of FW IC

Flowing chart

OK LOAD FW files OK Click program button OK Beginning programming OK


Turn off power if programming is OK 9

NG

Choose Config and adjust programming speed

13

You might also like