Scribd
Upload
46 views

Additional Formual For MDSP

gyufuyfdytdt

Uploaded by

userako21
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
46 views

Additional Formual For MDSP

gyufuyfdytdt

Uploaded by

userako21
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Shaft From No. 2a Bolts and Power Screw From No.

where: hp = power, hp N =angular speed, rpm D = shaft diameter, in d = set screw diameter, in

a = sensitivity factor r = radius stress raiser q = 0.983 Shaft ( )

Where: n = no. of set screw, dn = diameter in inches per no. of set screw From No. 12 V = NL V = linear speed in raising the screw, ft/min or m/min

where: hp = horsepower D = Diameter of shaft, inch N = angular speed, rpm Spring ( )

From No. 17 Square Thread Where: L = Lead Di = Root Diameter N = angular speed, rpm L = Lead, ft or m/min

Where: h = height of the object, m or ft W = weight of the object, N or lb k = spring rate, N/m or lb/ft = deflection of spring, m or ft Gear (From No. 5)

Pd = Diametral Pitch, teeth/diameter C = Center distance T1 = No. of Teeth 1 T2 = No. of Teeth 2

Brakes (From No. 2) T = average torque to stop the rotation, lb-ft I = Inertia Load, lb-ft2 = angular acceleration, rad/sec2 g = gravitational acceleration = 32.2 ft/sec2

T = average torque to stop the rotation, lb-ft wr2 = Inertia Load, lb-ft2 N =angular speed, rpm t = time, sec T = clutch starting torque, lb-ft I = Inertia Load or mass inertia, lb-ft2 = angular acceleration, rad/sec2 g = gravitational acceleration = 32.2 ft/sec2 T = clutch starting torque, lb-ft wr2 = Inertia Load or mass interia, lb-ft2 N =angular speed, rpm t = time, sec F = Force on the clutch Dm = Mean Diameter S = allowable stress Fa = axial Force, N or lb ) = cone angle, degrees Fn = Normal Force, N or lb

Clutch (From No. 3)

From No. 7

You might also like